What is the top speed of a CR125?

What is the top speed of a CR125?

Take a look at this site and go nuts with top speeds for all sorts of different bikes and gearing selections. But the CR85 is about 60mph and a stock CR125 is about 80mph. All the 85 and 125 MX bikes will have similar HP and top speed. My CR125 specifically, like 45 mph.

How fast is CR 85?

The Honda CR85 is capable of reaching a maximum top speed of 65 mph.

What happens if I don’t service my bike?

It is also mentioned that bikes not serviced according to schedule and with an authorized service center would lose warranty. The first service of a two wheeler is done at 500 -700 KM or one month of usage. During this service, Engine oil is changed and water service is done.

When should I replace my clutch plate on my bike?

If the torque transmitted by the clutch to the wheels is insufficient the clutch plates are worn out u need to change them. When u say u r not getting pickup it means either the setting of clutch is not ok or plates are worn out. U should change them at the earliest else the bike will consume more fuel.

How do I know if my clutch plate is gone?

If you’re experiencing any of the below symptoms, you may need a clutch replacement:

  1. Spongy, sticking, vibrating or loose clutch pedal when pressed.
  2. Squeaking or grumbling noise when pressed.
  3. Ability to rev the engine, but poor acceleration.
  4. Difficulty shifting gear.

What are the symptoms of clutch plate problems?

Sprag Clutch Failure Symptoms Often Include:

  • Clutch Pedal Makes Noises When Engaging and Disengaging.
  • Clutch Pedal Chatters When You Accelerate.
  • Clutch Pedal Pulsates.
  • Clutch Pedal Remains Stuck to the Floor.
  • Clutch Pedal Feels Loose or Spongey.
  • Clutch Pedal is Hard to Engage.

How do you check a clutch plate on a bike?

The following are the noticeable effects of a worn clutch plates:

  1. Reduced pickup and top speed.
  2. Pulsating feel when leaving clutch in gear.
  3. Hard gear shifts even after proper maintenance.
  4. Reduced clutch engage/disengage travel.
  5. Vehicle jerk when shifting gears from neutral.

How does a clutch plate burn on a bike?

Clutch Drag or Burn Disengagement becomes sticky because of melted friction surfaces. In excess cases, friction surfaces start burning because of overheating. Friction between clutch plates and pressure plate increases because of less lubrication and so does the heat.

Do I need to soak my clutch plates?

Soak clutch plates in the same engine oil used in your dirt bike or ATV. Dry clutch plates lose the fiber material faster thereby burning the clutch and wearing the steel plates faster, eventually causing the plates to slip or stick together. Ideally, soaking them overnight is best but an hour is OK.

How do you prevent damage to clutch plate?

Ways to avoid wearing out your clutch

  1. 1 Don’t ride the clutch.
  2. 2 Sit in neutral when stopped.
  3. 3 Use the handbrake when parking.
  4. 4 Change gear quickly.
  5. 5 Be decisive about gear changes.
  6. Save money on your clutch job.
  7. All about the Clutch.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top