Can I drive without my rear drive shaft?
Yes, you can if you remove the rear driveshaft. Basically you’d be in front wheel drive mode. Assuming you mean the u-bolt on the rear of the driveshaft It’s not going to hurt anything.
Can you drive with a broken drive shaft?
Yes, you can still drive with a faulty drive shaft but it is not recommended to do so for long. When part of the drive shaft snaps, you will lose power to that axle –best case scenario. The drive shaft can also fall and get wedged between your car and the ground, disabling you to make any forward movement.
Do you need a drive shaft?
It’s rather difficult to operate a vehicle without a drive shaft. The transmission output shaft would just sit there and spin. Front drive only vehicles essentially have two drive shafts. One for each front wheel.
What is a broken drive shaft?
A broken driveshaft can prevent wheels from turning properly, giving you trouble when trying to make turns. This issue limits your overall control of the car. You need any issues that prevent you from driving the car correctly addressed right away for safe driving and continued use of the vehicle.
How much does it cost to replace drive shaft?
You can usually expect to pay between $320 and $750 for the average cost of the parts, while the cost of the labor is between $150 and $190. If you have a rear wheel or four wheel drive car, then the price of the broken drive shaft repair cost will be much higher.
When should I replace drive shaft?
While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.
How long does it take to replace drive shaft?
That’s very difficult to answer due to the multiple variables involved in removing and replacing hard to access components such as the center driveshaft on a front wheel drive vehicle like your Edge. However, in general, this type of job can often be completed in one business day; or less than 8 service hours.
What does a bad drive shaft U joint sound like?
A clicking sound on a front-wheel drive vehicle is a pretty good indicator of bad CV joints. On rear or all-wheel drive vehicles, worn u-joints will often cause a loud clunking sound. A loud squeaking sound when traveling at low speeds can be a sign that your u-joint is dry and in need of lubricating.
Can a bent drive shaft be fixed?
To fix a damaged drive shaft that has been twisted or bent. The drive shaft tubing must be replaced and the other components must be checked for damage also. If your drive shaft has a dent in the tubing, most of the time you can straighten and balance the shaft to compensate for the dent in the tubing.
Does a new drive shaft need to be balanced?
Dented drive shafts cannot be rebalanced, they need to be replaced. Fortunately, you can fix minor imbalances by balancing the drive shaft, a procedure that requires minimal parts — only hose clamps.
Can you get a driveshaft balanced?
First, the driveshaft must be removed from the vehicle. This must be done by a professional. In order for the driveshaft to be properly balanced, it must remain completely intact, so make sure that the slip yoke, U-joints, and flanges are all still connected to the driveshaft when it is removed.
How long can you drive with a bad driveshaft?
How do I stop my drive shaft from vibrating?
If the vibration steadily increases with driveshaft speed (either accelerating or decelerating) the symptom is primarily the result of a driveshaft imbalance or yoke run-out. Sometimes this yoke run-out problem can be improved by rotating the U-joint 180-degrees in the rear end differential yoke.
Can transmission problems cause vibration?
Grinding, Shaking and Other Bad Vibrations An automatic transmission is more subtle in its signals, but they are unmistakable. Transitions into gear and between gears will cause some vibration at first; but then, as the problem persists, gear changes become more jarring and cause shaking.