How do you take the back seat out of a Hyundai Elantra?

How do you take the back seat out of a Hyundai Elantra?

How to Remove the Rear Seat of the Hyundai Elantra

1. Slide your hand into the crack between the upper and lower seat cushions. There is a bolt behind the right side of the lower cushion and the left.
2. Open the trunk and find the cushion release levers in the forward corners of the trunk, right next to the trunk lid hinges.

How do you remove the interior trim on a Hyundai Elantra?

Put on gloves to protect your hands. Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface….Take care not to bend or scratch the trim and panels.

1. Remove the rear seat assembly.
2. Remove the rear door scuff trim.
3. Using a screwdriver or remover, remove the rear pillar trim (A).

How do I use the panel removal tool?

Here’s how you do it:

1. To begin, reach behind the crank with the tool, then remove the ring.
2. Separate the crank from the panel.
3. Use a Phillips-head screwdriver to remove the screws holding the panel in place.
4. Remove the remaining screws, except for the plastic ones, which you can pull out with a pair of pliers.

How hard is it to replace a quarter panel?

Like all things in life, however, it’s not quite so easy. On the surface, it’s a simple job: cut the old quarter-panel off and weld a new one on. Like all things in life, however, it’s not quite so easy. Because you’re welding the new panel on, undoing a poorly done install can be a major pain in the butt.

How do you remove quarter panel skin?

Once you have made a rough cut on the quarter-panel, trim out the spot welds on the wheel lip and remove the remaining portion of the quarter. In some situations, depending on the amount of rust and the coverage area of the new skin, you will remove the spot welds and old quarter-panel along the rocker and trunk drop.

Can you replace quarter panel?

Automotive body repair is a very specialized process. Welding, sanding, alignment, and attention to detail are all part of the body repair process. Changing a quarter panel involves drilling spot welds, cutting excess metal, and replacing the old metal with new metal. …

What is the difference between a quarter panel and a quarter panel skin?

A full quarter will replace all of the original. A skin is a less expensive stamping to replace the vertical areas only, like a giant patch panel more or less, used to replace as much or as little required.

What is quarter panel damage?

IIHS classifies quarter panels as ‘cosmetic,’ but some might be structural. “The source of cosmetic parts is irrelevant to safety because the parts themselves serve no safety or structural function. They don’t affect how a vehicle holds up in a crash. They merely cover a car like a skin.”

Can you fix a rear quarter panel?

Depending on the level of damage, the auto body shop may be able to work on your rear quarter panel without removing it from your vehicle. However, if the damage is extensive, they may need to remove the rear quarter panel. The auto body shop may use a variety of different methods to smooth out your rear quarter panel.

Does frame damage total a car?

However, frame damage does not guarantee the vehicle is considered a total loss. Insurance companies consider a vehicle to be totaled if the cost of the necessary repairs exceeds the value of the vehicle. When in doubt, lean on a frame service that has proven it is worthy of its keep.

How do you fix a dented side panel?

Here are five quick and easy ways to remove minor damage from your vehicle’s exterior so that you can once again smile when you look at your car.

1. Try the plunger method.
2. Use hot water for dented bumpers.
3. Hammer out the dent.
4. Pop out the dent with a hair dryer and compressed air.
5. Buy a dent removal kit.