What is the bolt pattern for a Jaguar?
Jaguar XK8 Wheel Size
| XK8 Bolt Pattern (Lug Pattern) | PCD 5×120.70 See Adapters |
|---|---|
| Stock wheel offset | 15 to 25 mm Wheel Spacers |
| Center bore (hub bore) | 73.9 mm Use Hub Centric Rings |
| Thread size (Lug Nut Size) | M12 x 1.25 Lug Nuts |
| Stock Rim Sizes Range | 17×8.0 – 21×9.5 Hubcaps |
Can you drill rims to fit?
Fill and drill (as it is commonly known) involves welding the existing lug holes and then drilling a new bolt pattern on to the wheel. Reputable wheel shops can then drill out the lug holes to your required bolt pattern. These types of wheels are safe to be drilled and should be of no problem.
How much does it cost to get wheels Redrilled?
Re: how hard is it to get wheels redrilled??? You’re looking at about $600 for the set or so, to get them re-drilled (if there’s enough metal to weld to for filling in the original holes.
Can you Redrill 5×120 to 5×130?
5×130 RSs put the lug circle pretty close to the outer edge of the lug area, but the bolt holes are still within. Going from 5×114. 3 to 5×130, you’re only moving the lugs out by 8mm, after all. You will be fine.
Can you Redrill steel wheels to change stud pattern?
No. The wheel pattern is pressed into the rim as you will notice behind the wheel stud hole. Redrilling steel standard rims is a dangerous idea.
Can a rim bolt pattern be changed?
Wheel Adapters are used to change bolt patterns in order to properly fit wheels from one vehicle to the hub of a different vehicle. Wheel Adapters can also be used to adapt or fit aftermarket wheels meant for a different vehicle. Another common use would be adapting aftermarket or stock wheels to a trailer.
How do you enlarge a lug hole?
Enlarging holes or aligning mismatched holes in metal is the job of a tool known as a reamer. The process by which this is done is called Reaming and differs from traditional drilling as it requires an existing hole, or holes, as a starting point.