How do you clear the codes on a Jeep Liberty?

How do you clear the codes on a Jeep Liberty?

How to Clear Engine Codes for a Jeep Liberty

1. Open the driver’s side door of the Jeep Liberty and locate the diagnostic link connector (DLC) under the dash.
2. Plug the pocket scanner into the DLC and then turn the ignition key to the accessory position.
3. Read the onscreen menu of the scanner.
4. Choose “Erase” as an option.

Why is my check engine light on in my Jeep Liberty?

The check engine light for the Jeep Liberty means that the on-board diagnostics or the OBD detected a problem with the engine, emission system or the transmission though it is less common for it to be the transmission.

How do you reset the check engine light on a 2008 Jeep Liberty?

Turn the key in the ignition to the “on” and then the “off” position three times in succession and try starting the engine. Disconnect the positive battery cable for 15-20 minutes.

CAN OBD codes?

OBDII Codes List

• P0171 System Too Lean (Bank 1)
• P0174 System Too Lean (Bank 2)
• P0300 Random/Multiple Cylinder Misfire Detected.
• P0301 Cylinder 1 Misfire Detected.
• P0340 Camshaft Position Sensor Circuit Malfunction.
• P0401 Exhaust Gas Recirculation Flow Insufficient Detected.

How do you reset the service light on a Jeep Commander?

Jeep Commander OIL CHANGE REQUIRED Reset

1. Close all doors.
2. Set the gear to the PARK position.
3. Turn ignition to RUN position, don’t start the engine.
4. fully depress the accelerator pedal slowly three times within 10 seconds and the OIL CHANGE is reset.

How do you reset the oil change light on a 2006 Jeep Grand Cherokee?

Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.” This will turn off the service light on the display.