Can a stick be used as a machine?
Wait, how is a stick a machine? It doesn’t take gas or electricity. Cooper: It is a machine! The way to figure it out is to think about whether it can transmit work.
When you raise or lower a flag on a flagpole you are using a?
Work and Machines
| Question | Answer |
|---|---|
| When you raise or lower a flag on a flagpole, you are using a… | pulley |
| What do machines do? | change the amount of force you exert or the distance over which you exert the force |
| Power is measured in units called… | watts |
| An ideal machine would have an efficiency of… | 100% |
What simple machine would you use to take the flag down?
pulley
Can be considered a type of inclined plane wrapped around a cylinder?
A screw is an inclined plane wrapped around a cylinder.
What is an inclined plane wrapped around a rod an example of a wheel and axle a lever a pulley a screw?
Explanation: There are several forms of an inclined plane, for the question asked, a screw best satisfies the question asked as it is a typical example of an inclined plane wrapped around a rod.
Do you put knobs on fake drawers?
I would recommend putting pulls on the dummy drawers it allows for consistency. Good design is always consistent. It will also give the illusion that these drawers are not fake. The idea of putting a minimal intrusive towel bar works well because then it will serve more for function then aesthetics.
What is the correct height for a door handle?
900mm
What height does a door handle need to be?
34 inches
How high should a door handle be UK?
1000mm
How wide is a door handle?
The industry standards are usually 44 mm/ 57mm / 82mm / 107mm / 130mm. Ideally you will try and choose the backset measurement that sites the door handle in the middle of the door stile. A shorter backset is recommended if you’re using a glazed door.
What makes a door handle ADA compliant?
To comply with ADA standards, a door handle may be no lower than 34 inches from the floor and no higher than 48 inches above the floor. This is measured from the surface itself, and not from the bottom of the door. So be aware of that distinction as you go to measure your handle height for each door.