What is the disadvantages of integrated circuit?
Limited power rating as it is not possible to manufacture high power (say greater than 10 W) ICs. Need of connecting inductors and transformers exterior to the semiconductor chip as it is not possible to fabricate inductor and transformers on the semiconductor chip surface.
Which integrated circuit is having more than 1000 gates?
A large-scale integration (LSI) IC contains from 100 to 1,000 transistors, and one that uses very-large-scale integration (VLSI) contains more than 1,000 transistors.
What is the most difficult to fabricate an IC?
Q15. Which of the following is most difficult to fabricate in an IC?
- Diode.
- Transistor.
- FET.
- Capacitor.
What is IC in semiconductor?
Integrated circuit (IC), also called microelectronic circuit, microchip, or chip, an assembly of electronic components, fabricated as a single unit, in which miniaturized active devices (e.g., transistors and diodes) and passive devices (e.g., capacitors and resistors) and their interconnections are built up on a thin …
Why inductor is not used in IC?
inductors being 3D (physically) simply can’t be made inside IC, however flat (in a plane) spiral inductors can be made but they take lots of silicon area while providing very small value of induction. Thus not cost effective.
What is application of inductor?
They are used to block AC while allowing DC to pass; inductors designed for this purpose are called chokes. They are also used in electronic filters to separate signals of different frequencies, and in combination with capacitors to make tuned circuits, used to tune radio and TV receivers.
Why capacitor is used in DC motor?
The capacitor helps to keep constant the DC motor current and smooth the motor speed. As we know, very frequently connect and disconnect happens between the brushes and commutator inside the DC motor. So, the motor draws a frequently changing current from the power supply. Here the capacitor helps!
Which capacitor is used in DC motor?
if we notice it carefully it has some electronic component which is connected in parallel with the supply terminal, the component is known as Ceramic capacitor which is connected with motor. There are various reasons why this ceramic capacitor is use with this Dc motor or gear motor.
Is capacitor used in DC?
When used in a direct current or DC circuit, a capacitor charges up to its supply voltage but blocks the flow of current through it because the dielectric of a capacitor is non-conductive and basically an insulator. At this point the capacitor is said to be “fully charged” with electrons.
How does a capacitor reduce noise?
A. Capacitors interrupt direct current and let alternating current pass. For electronic devices that run on DC voltage, elements of an alternating-current become noise that makes operation unstable. As a countermeasure, capacitors are connected so as to allow the AC elements to pass through to the ground.
Can I replace a capacitor with a higher capacitance?
The first point is that higher value capacitors ,at the same voltage rating are usually physically bigger. It is usually safe to replace a capacitor with the same value but with a higher voltage rating but the capacitance may be at its value for a reason. There’s more than just capacitance at play, too.
How do you reduce noise in an amp circuit?
Just stand/sit a certain distance away from the amp while you are playing. You’ll see that the noise reduces when you clamp down on your strings. Simply put, when you stand too close the strings might pick up vibrations and vibrate themselves, causing the noise. Reduce the gain.