How much horsepower does a 1994 Chevy Silverado have?
The 1994 Silverado came with two different engines, depending on the trim level of the truck. These were the 4.3-liter, V-6 engine that produced 165 horsepower and 236 foot-lbs. of torque, and the 5.0-liter, V-8 engine, which produced 175 horsepower and 270 foot-lbs. of torque.
Can you put a camshaft in wrong?
YES, you can install the cam so it is off. If the dot on the cam gear is UP, and the dot on the crank gear is UP, it is 180 degrees off and will not run. If the dot on the cam gear is UP, and the dot on the crank gear is UP, it is 180 degrees off and will not run. …
Can you put a cam in backwards?
It should run just fine either way. Even the timing marks would line up. The notch up, the dot level with the sealing surface. This would time it 180 out, the dot would be in front not the rear.
Is it bad to rotate an engine backwards?
When a motor is turned backwards, the timing relationship between the crank (timing mark) and the cam (distributor, etc) changes, so parts can be installed out of time, etc. You can turn it backwards, then just need to turn it back forwards enough to remove the slack, restore the timing relationship.
How do you clock a camshaft?
Timing in the Camshaft. Rotate the crankshaft clockwise to 90 degrees after TDC. This will make sure all the pistons are half way down the bore. Now position the dial gauge so that it can read the lift of the inlet valve of number 1 cylinder from the top of the valve retainer (see left).
What is the difference between a camshaft and crankshaft?
A camshaft uses egg-shaped “cams” to open and close engine valves (one cam per valve), while a crankshaft converts “cranks” (the up/down motion of the pistons) to rotational motion.
What does a bad camshaft sound like?
The symptoms of a bad camshaft include frequent backfiring and popping. You may also experience cylinder misfires at low and high speeds. Additionally, if your camshaft lobes are worn, you may hear tapping and ticking noises from the upper engine.