Why is my 2013 Dodge Avenger overheating?
While there are a variety of reasons your Dodge Avenger is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat.
How do you fix an overheated car?
If your engine is overheating, do the following to cool it down:
- Turn off the air conditioner. Running the A/C puts a heavy load on your engine.
- Turn on the heater. This blows some excess heat from the engine into the car.
- Put your car in neutral or park and then rev the engine.
- Pull over and open the hood.
Does a 2013 Dodge Avenger have 2 thermostats?
The vehicle with this engine size is equipped with a primary and a secondary thermostat in the cooling system. The primary and secondary thermostat open at different temperatures. The secondary one opens up at 203 F and should be fully open at 230 F.
Where is the thermostat located in a 2013 Dodge Avenger?
The thermostat in a 2013 Dodge Avenger equipped with a 3.6 liter engine can be found under hood to the left of the engine below the oil reservoir on the passenger side of the engine bay.
Why would a car have two thermostats?
Their purpose is more for aerodynamics than engine cooling. The dual thermostat system was designed to accomplish the same temperature control under different load conditions. Instead of manipulation of the air side of the radiator, the coolant flow to the radiator is varied.
Why is my Dodge Avenger leaking coolant?
A ruptured heater core would cause coolant to leak into the front passenger floorboard. If too much coolant is leaking, it could lead to an overheating situation and damage the engine. Coolant leaking out of the water pump due to a failed seal is common on a dodge avenger.
What kind of antifreeze for 2008 Dodge Avenger?
Zerex Yellow
How do you put antifreeze in a 2008 Dodge Avenger?
How do you put coolant in a 2008 Dodge Avenger?
- Getting Started.
- Open the Hood.
- Find Reservoir. Locate the coolant reservoir and clean it.
- Check Level. Determine the coolant level.
- Add Coolant. Determine coolant type and add fluid properly.
- Replace Cap. Secure the coolant reservoir cap.
- Locate Hoses.
- Assess Hoses.
What color antifreeze does Dodge Avenger use?
Yellow
What kind of antifreeze does a 2013 Dodge Avenger use?
Notes: Dex-Cool 50/50, Premixed Do Not add water.
How much coolant does a Dodge Avenger take?
The Avenger has a coolant capacity or 4.5 quarts. If You choose to have it replaced by a professional mechanic, You can expect to pay an additional $40 to $102 for labor. This fluid comes pre-diluted, meaning You do not need to add anything to itS50 percent water, 50 percent coolant combination.
How much antifreeze does a 2013 Dodge Avenger hold?
| Engine lubricant oil capacity: | 4.23 liter / 4.5 U.S. qt / 3.7 imp. qt |
|---|---|
| Engine coolant capacity: | 6.8 liter / 7.2 U.S. qt / 6 imp. qt |
| Fuel tank capacity: | 64 liter / 16.9 U.S. gal / 14.1 imp. gal |
Where does antifreeze go in Dodge Avenger?
Pop the hood of your car. You must quickly find the expansion tank that contains the coolant of your Dodge Avenger, it is usually found in one of the 4 corners of your engine block, to find it you just have to look for a plastic container with a black or yellow plastic cap with a danger logo or thermometer on the top.
What coolant does a 2014 Dodge Avenger take?
Zerex 1 Gallon Orange 50/50 Coolant/Antifreeze.