How do I find my engine diagnostic code?
To read the codes, you will have to plug a scan tool or code reader into the 16-pin OBD II diagnostic connector, which is usually located under the dash near the steering column. The tool will then display the code or codes that have turned on the Check Engine Light. To read codes, you need the proper scan tool.
How do you reset the codes on a Dodge Avenger?
Turn on the ignition but don’t crank the engine. Wait 5 minutes and then replace the ECU fuse. The “check engine” light will blink and then shut off. This will reset the light.
How do you reset the gas light on a Dodge Avenger?
Connect the scanner to the OBD-II port. You’ll find this beneath the steering column. It looks very similar to a port You would find on the back of a computer. On the code scanner, select the “Reset” button.
Why is my check engine light on in my Dodge Avenger?
This indicator is part of the onboard diagnostics (OBD-II) system and in all cases it indicates a problem with your emissions system. Basically, it is an emissions monitoring system. A Check Engine indicator will stay solid or blink.
Where is the ECU fuse on a 2013 Dodge Avenger?
The fuses that run the interior of a 2013 Dodge Avenger are actually located in the engine compartment. This fuse box is called the integrated power module, and it contains many different fuses and relays. You can find it to the right of the engine, near the air filter assembly.
Where is the ECU fuse on a 2011 Dodge Avenger?
All of the fuses and relays for the Avenger are located in the “Integrated Power Module” on the right side of the engine bay. Press the two release tabs on the rear edge of the fuse box cover and lift it straight off.
Where are the fuses on a 2012 Dodge Avenger?
The 2012 Dodge Avenger Integrated Power Module (fuse box) is situated near the air cleaner system in the engine compartment. This fuse panel includes fuses and small fuses for cartridges. A diagram can be printed on the inside of the cover that distinguishes each part.
Where is the anti theft fuse on a 2008 Dodge Avenger?
The fuse box is to the left of the engine between the windshield washer fluid reservoir and shock tower.
Where is the fuse for the horn on a 2010 Dodge Avenger?
It is housed in a long black boxAgainst the firewall and generally in front of the battery. It will be mounted on the underside of the installed fuse box.
How do you turn off the alarm on a Dodge Avenger?
To Disarm The System Either press the UNLOCK button on the RKE transmitteror insert a valid Sentry Key into the ignition lockcylinder and turn the key to the ON/START position. NOTE: The driver’s door key cylinder and the trunk button onthe RKE transmitter cannot arm or disarm the VehicleSecurity Alarm.
Where is the radio fuse on a 2014 Dodge Avenger?
There are two fuse box locations on Your 2014 Dodge Avenger. One is to the left of the steering wheel, in the dashboard, and controls a lot of the interior components, like the radio and lights. The other one is located in the engine compartment, near the air cleaner assembly.
How do you open the trunk of a Dodge Avenger?
Use the Remote Keyless Entry (RKE)transmitter to open the trunk fromoutside the vehicle. From inside thevehicle the trunk lid can be released bypressing the TRUNK RELEASE buttonlocated on the instrument panel to theleft of the steering wheel. NOTE: The shift lever must be in PARK for this switchto operate.
Where is the starter relay located on a 2014 Dodge Avenger?
The relay is the middle one of the three relays in the fuse box under the hood. These are on the outer edge.