What causes gear shift to stuck in park?

What causes gear shift to stuck in park?

An open circuit in the shift interlock electrical system can cause the shifter to become stuck in Park if the open circuit interrupts communications between the brake light switch or the ignition switch and the interlock solenoid. If power is present, the shifter interlock solenoid is bad.

Where is the alarm fuse on a 2008 Dodge Avenger?

The fuse for the alarm in a 2008 Dodge Avenger is located in the engine compartment fuse box. To get to it, first You will need to open the hood, pull the hood release lever which is located below the headlight control knob at the bottom of the kick panel.

Can you replace a TIPM yourself?

Once you have narrowed down the TIPM as the source of the problem, the replacement is simple. Even though technically the TIPM does not need to be programmed, it does need to be configured to the car. Therefore, a “Restore Vehicle Configuration” will be needed, which requires the VIN to be entered into the TIPM.

How do I know if my TIPM is bad?

Related Symptoms of a Failing TIPM

1. The transmission is in fail safe.
2. The air bag light stays on with no service codes.
3. The engine stalling while driving.
4. The starter cranks but won’t start.
5. The fuel pump not turning on or off.
6. The horn going off at random times or does not work.
7. Power windows not working.

What is the IOD fuse for?

The ignition Off Draw (IOD) fuse is used to prevent battery discharge during shipping or long-term storage of the vehicle. The IOD fuse is located in the Total Integrated Power Module (TIPM). If the fuse is not completely inserted, partial contact of the fuse terminals could occur.

How do you remove IOD fuse?

When replacing the IOD fuse, you’ll want to pull up the casing until it won’t pull up anymore. Don’t force it. Then take a small screwdriver and pry open the top part of the casing. Once open, remove the fuse and replace it with a new one.

What is Illum fuse?

The ILLUM 10 Amp fuse that is located on the internal fuse block is blowing. It does not always blow right away. It is a 10 amp fuse labled in the WH manual as ILLUM protecting the Instrument Panel Cluster, Audio Alarm, Body Builder Feed.

How do you remove an ignition fuse?

(1) Turn the ignition switch to the Off position. (2) Remove the fuse access panel by unsnapping it from the left outboard end of the instrument panel. (3) Grasp the upper and lower tabs of the IOD fuse holder unit in fuse cavity 12 of the JB between the thumb and forefinger and pull the unit firmly outward.

What does ignition off draw mean?

The term Ignition-Off Draw (IOD) identifies a nor- mal condition where power is being drained from the. battery with the ignition switch in the Off position.

What is the reason for installing the ignition off draw fuse?

The only reason the IOD fuse is removed is to reduce the normal IOD of the vehicle electrical system during new vehicle transportation and pre-delivery storage to reduce battery depletion, while still allowing vehicle operation so that the vehicle can be loaded, unloaded and moved as needed by both vehicle …