How do you reset the oil light on a 2009 Dodge Nitro?

How do you reset the oil light on a 2009 Dodge Nitro?

Oil Change Light Reset Dodge Nitro 2008 2009 2010 2011 Procedure

1. Turn the ignition to the “RUN” position.
2. Immediately press and release the accelerator pedal 3 times within 10 seconds.

How do you reset the change oil light on a Dodge Nitro?

Dodge Nitro Oil Change Message Reset

1. Shift the gearbox to Park Position.
2. Close all doors.
3. Push the start button to RUN Position (Ignition On) Don’t start the engine.
4. Fully depress the GAS PEDAL slowly three times within 10 seconds Make sure to depress the pedal all the way down.

How do you reset the computer on a 2008 Dodge Nitro?

This will reset the computer also….If you want to reset your truck.

1. Turn on the key and eluminate all the warning lights (Do not start).
2. Depress accelerator three times to the floor quickly.
3. Turn off the power (pause).
4. Start truck normally.
5. Drive it like you stole it.

How do you reset the computer on a 2008 Dodge Caliber?

Turn ignition key but dont start car, press and depress gas pedal 3 times within 10 seconds, turn off car and remove ignition key. That ought to do it.

How do I reset my Dodge ECM?

To turn it off, you’ll need to reset the computer….Turning Off the RAM 1500 Check Engine Light

1. Identify your battery’s negative cable.
2. Disconnect the negative cable from the battery.
3. Wait 20 minutes so that all systems have shut down.
4. Reconnect the negative cable.

How do you reset the ECM on a GMC Sierra?

How to Clear a GMC ECM

1. Loosen the bolt on the black battery cable until the connector opens enough to come off the battery stud.
2. Turn the headlights on for several seconds to use up any stored power, then return them to the “off” position.

Does disconnecting the battery reset the computer?

Will Disconnecting a Car Battery Reset The Computer? The answer is, maybe. Disconnecting the battery for a short time may not do the trick because the car’s computer, or ECU, still has some current in it. Waiting for over 15 minutes after disconnecting the engine will help ensure the equipment is reset.