How do you reset the check engine light on a sprinter?

How do you reset the check engine light on a sprinter?

Press the button on Your steering wheel (lower left) to have the display light what needs servicing. Then, hold down the reset button on the left of that instrument panel, keeping it depressed for at least three seconds. Release it, and then push it in again until the display confirms the reset.

Can you reset the check engine light by disconnecting the battery?

Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. Disconnecting the battery will clear the error codes and reset the check engine light.

How long does it take for OBD to reset?

There may in fact be nothing wrong with the vehicle; the computer simply needs to complete its checks. One week of combined highway and city driving is normally enough to reset the system and provide an accurate reading of vehicle performance.

How do I reset my OBD monitor?

Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes. Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle.

How do you know when OBD2 is ready?

To determine if readiness OBD II monitors are complete:

1. Turn the ignition key to the “on” position for 15 seconds without cranking the engine.
2. If the “Service Engine Soon” light blinks eight times, one or more readiness monitors are incomplete.

How do I reset my drive cycle?

How do you do a Drive Cycle?

1. Clear all OBD II error codes with your OBD2 Scanner.
2. Ensure your fuel tank is somewhere between 30% and 70% full.
3. Check the quality of your battery and alternator.
4. Let your vehicle rest for eight hours.
5. Start your car, put it in the park or neutral, and let it idle for two or three minutes.

What is OBD bulb check failure?

OBD II TEST An inspector checks to see if the MIL light comes on when the key is turned on. If the light does not come on, the vehicle fails the bulb check. A scanner similar to AutoTap is plugged into the diagnostic link connector (DLC), and the system is checked for monitor readiness.