Where is the low beam relay?
Find the headlight relay closure: Usually, it is under the hood of the car. The point where your fuse panel is most likely located. On the other hand, it may also be located inside the cab of the car, this would be the case if your car comes with an interior fuse box.
How do I know if my low beam relay is bad?
Replace the Relay Have an assistant turn on the headlights. If you hear the relay click, you know the coil is working, but you don’t know about the contacts. If you don’t hear the click, your relay is probably bad. The safest way to test a headlight relay is to replace it with a known good one.
What are the most probable causes for one low beam headlamp not working?
Most total headlight failures are caused by a bad component like a fuse, relay, or module. High beam headlights don’t work or low beams don’t work. The cause: A burned out bulb, or a problem with the high beam switch or relay. The fix: Replace the bulb, switch, or relay.
Why is low beam not working?
The likely cause is a fuse, headlight relay, headlight switch, dimmer switch or a wiring fault. About the only cause that is an easy fix is a blown fuse. Consult your owner’s manual to locate the main fuse for the headlight circuit and replace that fuse with one having the same amp rating.
What would cause high beams not to work?
By far the most common reason your brights will stop working is from a blown fuse or a bad relay. Or, it could be a bad relay. If the headlight relay has failed, it may not respond when you attempt to switch the high beams on. Replacing the relay should restore the system and get your high beams working once again.
Where is the fuse for the headlights?
It is often located in the power center in the engine compartment, but may also be in the fuse panel under the dash. If the fuse has blown, replace it with a new fuse (same amp rating) and try again. The first, and easiest, component to check is the headlight fuse.
Are high and low beams the same bulb?
Most modern vehicles have a single bulb with two filaments. Some cars (mostly higher-end vehicles or performance vehicles) do have separate bulbs for their high and low beams. Generally, you’ll have a standard halogen bulb for low beams, and then an HID bulb for your high beams. These are not interchangeable.
What do you do if someone has their high beams on?
If an approaching car is using its high-beams, don’t look directly into the oncoming headlights—look toward the right edge of your lane. Watch the oncoming car out of the corner of your eye. Do not try retaliating against the other driver by keeping your high-beam lights on. If you do, both of you may be blinded.
How high should low beams be?
The top of the low beam shining on the wall should be at or slightly below the height of the center of the headlight lens for most vehicles. You should expect the light pattern to be higher on the right side (passenger side) to illuminate road signs and lower on the driver’s side to prevent blinding other drivers.