How do I reset my Tork timer?

How do I reset my Tork timer?

How to Set Tork Timers

1. Press and hold the “Clock” button.
2. Press the “Day,” “Hour” and “Min” buttons (while continuing to hold “Clock”) to set the day, hour and minutes.
3. Release “Clock” when you set the desired time.
4. Press the “Reset” button.

How do you program Tork?

To program your Tork timer:

1. First, open the switch’s cover and locate the 24-hour time dial.
2. Next, set the “On” and “Off” times by adjusting the two mechanical triggers attached to the dial.
3. The silver trigger will turn the system on; the black trigger will turn it off.
4. Adjust the 24-hour dial to match the time of day.

How do you set the outdoor timer on a Tork 602b?

SIMPLE TO USE: Push all the tabs defining the ON time duration outward and the OFF time duration inward to set timer.

How do you set a hyper tough timer?

Simply plug the timer into the outlet and attach the appliance power plug. The timer is programmable with 30-minute intervals; push pins down to set desire (ON) times and pull pins up to set (OFF) times. The pins are easy to use and built-in for convenience.

How do you set a timer?

Timer

1. Open your phone’s Clock app .
2. At the top, tap Timer.
3. Enter how long you want the timer to run.
4. Tap Start .
5. When your timer finishes, you’ll hear beeping. To stop the beeping, tap Stop .

How do you set a mechanical pool timer?

To set the time, pull the Intermatic Clock-Dial outward. Turn the dial in either direction and align the exact time of day on the Clock-Dial to the Time Pointer. The picture displays the timer set to 12:00 pm.

How many hours should my pool pump run?

8 hours

Why is my Intermatic timer not working?

If power is reaching the clock, but the motor gears are not turning, that usually means either something is jammed in the gears (I once found a gecko tail), or the timer motor has burned out. It could also be loose wires, either on the time clock terminal board, or on the timer motor.

Why is my light timer not working?

If the timer doesn’t activate the connected light, it might be working but the light bulb in the fixture might be burned out. Get on a sturdy ladder and twist the bulb fully into the socket. If the light still fails to turn on, the light bulb might be burned out. Replace the bulb with a new one.

How do you test a timer switch?

Touch the two probes of the volt-ohm meter to the contact points to be tested. Turn the dial of the timer to the appropriate cycle that is being tested. There should be no continuity reading on the volt-ohm meter during the test. If there is a reading on the volt-ohm meter, the timer is faulty.

Why is my outdoor timer not working?

If your landscape lighting timer isn’t working try resetting it by pressing the Reset, Restart, or R button in your transformer. Then set it up again. If that doesn’t work then you may need a new timer.