How do you reset the anti theft system on a car?
Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car.
How do you reset the anti theft on a 1998 Ford Expedition?
Put the key in the ignition and turn it to the run position. Theft indicator proves out after 2 seconds and then flashes rapidly. After 15 minutes of flashing, The theft indicator will stop flashing. Within/Before a few minutes (5 I believe), after it has stopped, turn the key off and then back to run.
How do I know if my car is in anti theft mode?
If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.
How do you bypass a Ford PATS system?
Can you bypass the PATS system? Yes, there is a simple way to bypass the pats system on your own. All you need is the transponder key to trick the system. By having the transponder key, you can remove the chip inside the key and glue it to the ignition and use any key that matches the original to start up the engine.
How do I clear p1260 code?
Try turning the key on and then leave it for a few minutes, or until the theft light stops flashing. Then start the vehicle. This will reset the system if the transceiver in the column is working.
What is a P1000 code?
Trouble code P1000 DTC is a manufacturer specific trouble code, most commonly used by Ford, Jaguar, and Mazda. It simply means that the engine control computer (ECC) has not completed its emission systems testing. A vehicle’s engine computer must complete multiple self-tests known as Readiness Monitors.
What is Pat transceiver?
The PATS transceiver is mounted on the ignition lock cylinder housing and is connected to the PATS control module. The transceiver energizes the transponder key electronics through the key’s circular antenna. The PATS transceiver receives data from the control module through the transmit Tx signal.
How do I turn off the anti theft system on my Ford Explorer?
You can pop the hood and disconnect the positive battery cable, then leave it off for about 30 minutes. This will make the power in the CPU drain, which will force the system to reset itself the next time it comes on. The other option is to pull the fuse from the fuse boxAnd wait a similar amount of time.
How do you know if your car has Pats?
PATS began in 1998. That being said, if your truck was manufactured in late 1997 it’s possible it might have been built with PATS. If your ignition key is just a plain metal key, you don’t have PATS. PATS used an RF transponder key with a rather large plastic grip.
What is Pats on a Ford?
What Is Ford SecuriLock® Passive Anti-Theft System (PATS)? SecuriLock is an engine immobilization system. It helps to prevent anyone from starting the engine without using a coded key programmed to your vehicle. Using the wrong key could prevent the engine from starting.
How do I reprogram my Ford PATS key?
Turn the ignition cylinder ON (RUN) for three seconds, then turn it back to OFF. 5. Within ten seconds, remove the first original key and insert the second original key, and then turn to ON (RUN) for three seconds, and then back to OFF. 6.