How do you reset a PCM Ford Explorer?
How to Reset the Ford PCM
- Open the hood of the Ford. Loosen the lock nut located on the negative battery cable connector with a socket and ratchet.
- Wait for 20 minutes while the PCM bleeds off the electricity it stores for backup power. Once the power drains from the PCM, it resets.
Where is the PCM on a 2001 Ford Explorer?
computer where is it located It is under the hood with the body of the module (called the PCM) sticking inside the passenger compartment, it come out from under the hood.
Where is the PCM on a 2004 Ford Explorer?
The PCM is located in the rear of the Engine compartment on the passanger side.
Where is the PCM located on a 2004 Ford Focus?
Ford did a good job of hiding the ECM (electronic control module) on the Ford focus. Many Ford vehicles have the ECM mounted inside the engine bay, and some older models have the ECM mounted behind the kick panel, on the passenger side of the vehicle. With the Focus, Ford has found a new location: behind the glove box.
Where is the PCM on a 2002 Ford Explorer?
Located on passenger side, can see the connections from under the hood.
Where is the computer module on a 2006 Ford Explorer?
On the passenger side lift up the wiper look thru the windshield above the glovebox. using a penlight you should see the module with the sticker on top.
Where is the PCM located on a 2003 Ford Ranger?
Most 2000-2003 ranger wiring docs say its located under the hood on the passenger side firewall.
Where is the computer on a 94 Ford Ranger?
On a 94 drivers side under hood on firewall between brake booster and inner fender.
Where is the computer located in a 2000 Ford Ranger?
The PCM is on the firewall, a bit left of center, with a large connector attached to it.
How do you reset the computer on a 2001 Ford Ranger?
To reset the pcm memory on a ford ranger you will need to disconnect the negative battery terminal and allow the battery terminal to be disconnected for at least 20 minutes, then reattach the cable and start the vehicle.