What is the safest way to cross a railroad track with a forklift?
Cross railroad tracks on the diagonal to prevent damage to wheels and to keep the load from slipping. Don’t allow unauthorized drivers on your forklift and especially don’t let the forklift be used for horseplay. Drive in reverse (except up slopes) if the load blocks your view.
How do you drive over railroad tracks?
Any driver of a motor vehicle approaching a railroad crossing sign shall slow down to a reasonable speed. If required to stop, driver shall stop at the marked stop line. If there is no line, driver shall stop no less than 15 feet nor more than 50 feet from the railroad crossing.
When operating a forklift over railroad tracks cross at a?
Question: What is the correct way to cross railroad tracks in a forklift? You should cross them carefully and slowly It’s best to move across diagonally, so that one wheel at a time crosses the tracks You should only cross at approved crossings.
When driving or operating a lift truck over or near railroad tracks you should?
Never drive straight across speed bumps or railroad tracks. Cross slowly at a 45 degree angle. Maintain steering control by keeping contact with the ground at all times.
Why do you need to know the power source of a lift truck?
you need to know the power source of a lift truck you plan to use because: It may not be compatible with your work area, or may create a potentially hazardous atmosphere. What are the most common types of lift truck accidents?
What is the most important safety device on your lift truck?
Brakes
How long does it take to stop a lift truck that is traveling at full speed?
It will take another 10 feet for the forklift to come to a full-stop. If the forklift is going 8 mph, the distance jumps to 42 feet. At a speed of 9 mph the distance jumps up to 51 or more feet.
What is the first thing to do before driving into a trailer?
The first thing you should do each time is walk into the trailer to make sure it’s safe: Make sure the trailer is well lit inside. Check that your lift mast will clear the ceiling. Check the floor for obstructions or loose objects, and look for holes or weak points.
What should you check before lifting a load?
Check that the overhead clearance is adequate before raising loads. Do not raise or lower the fork unless the lift truck is stopped and braked. Lift loads straight up or tilt back slightly. Do not lift a load that extends above the load backrest unless no part of the load can possibly slide back toward the operator.
Should the trailer wheels be choked or a dock lock system be engaged prior to loading or unloading?
Block the wheels of a vehicle before loading or unloading to prevent it from moving. Brakes alone can only do so much to stabilize a vehicle. Make sure dock plates are secured into position before using them.
When traveling load load should I lift?
allow 2 to 3 inches of clearance at the sides and back of the load; move the load slowly into position; tilt the load forward, then lower it; level the forks so they are no longer tilted; and.
What happens to the center of gravity when you lift a heavy load above the forklift answer?
Heavier loads shift the center of gravity forward even further. Raising the load also shifts the center of gravity forward. In order to prevent the lift from tipping, the combined center of gravity of the load and the lift must stay inside the stability triangle (at ground level) at all times.
Where is the center of gravity for a loaded forklift?
Forklift Load Stability Terms and Definitions Center of gravity – The point on an object at which all the object’s weight is concentrated. For symmetrical loads, the center of gravity is at the middle of the load. Fulcrum – The forklift’s axis of rotation when it tips over.
Which truck will resist tipping over sideways?
Forklifts have a “stability triangle”. A vertical line extending from the center of gravity of the vehicle and load combination must be inside of the stability triangle to prevent the forklift from tipping forward, falling sideways or dropping its load, as shown in the diagram below.