How do you read a Toyota forklift serial number?
The model series is followed by a series of letters, the first of which designates the category of the industrial vehicle. A “B” after the model series designator indicates the forklift has baselegs, which is commonly seen in model numbers for reach trucks and walkie stackers.
How much does a new Toyota forklift cost?
A brand new, electric forklift with standard capacity might cost $20,000 – $45,000 dollars and up with an increase of $2,500 – $5,000 for a battery and charger. An internal combustion forklift with standard capacity will cost approximately $20,000 – $50,000 and up.
What is the average life of a forklift?
10,000 hours
Whats high hours for a forklift?
Since the high hours of a forklift tends to hover somewhere between 10,000 hours to 20,000 hours, you can expect your forklift to last for seven years maximum. Much depends on how extensively the machine was used. Another factor is the number of times the machine needed to be recharged per usage.
When should I retire my forklift?
The best time to sell or trade-in your used forklift is before the 10,000 hour or seven year mark. Keep in mind that electric forklifts typically last longer than ICE lift trucks. If you manage a multi-shift operation, consider trading in your equipment even sooner.
How often should you replace a forklift?
Planned Replacement is Key to Success As a general rule, forklifts have an economic life of approximately 10,000 to 12,000 hours. Again, this varies based on maintenance practices, operating conditions and the type of equipment used. Every operating and ownership situation and application is different.
What are forklift tines?
Forklift forks, also known as tines or blades, are used to lift and carry loads. They are an integral part of the forklift and ensuring you are using the correct ones and that they are in good condition is essential to both the safety of personnel, but also the forklift and the load.
How do you read forklift forks?
Check blade and shank angle – If the shank and blade angle exceed 93 degrees, the fork must be replaced. Do not allow machine shops to bend forks back into place! Ensure straightness of blade and shank – If the shank or the blade are bent, the fork can no longer be used.
How thick are standard forklift forks?
1-3/4″
How tall is a standard forklift?
between 10 and 15 ft
How wide do forklift forks go?
High capacity forklifts can have fork spacings as much as 9 or 10 feet. Generally, the forks can be adjusted from almost no clearance between them to the maximum spacing of the particular lift truck.
How high is a 2 stage forklift?
A typical two stage mast for a forklift with a capacity from 2,000 lbs. to 6,000 lbs. will have approximately 130″ of maximum lift and will be around 83-88″ Overall Height Lowered (OAHL). Two stage masts are very common in high capacity forklifts of 15,000 lbs.