Does a 2002 Pontiac Grand Am have a cabin air filter?
No. 2002 Pontiac Grand Am is not equipped with a cabin air filter.
Does a 2002 Pontiac Grand Am have a chip in the key?
2002 Pontiac Grand Am Ignition Chip Key Transponder Programming Instructions. Step by Step How to Programming Instructions: This vehicle is NOT equipped with a chip key transponder system so no programming is required for ignition key.
How do you reset the security on a Pontiac Grand Am?
How do you reset the security on a Pontiac Grand Am? Turn the key to the on position for 10 minutes then turn off , repeat 2 more times. the system should reset . Mine usually resets on the second time, if the security light stops flashing then i try to start.
How do I disable GM Anti theft system?
How to Disable a GM Passkey System
- Insert your GM key into the ignition, attempt to start the car, and let it stall. After it stalls, leave the key in the starter in the “On” position.
- Look at the “Theft Sys” light blinking on your dashboard and wait until the light stays on without blinking.
How do I fix theft passlock on GM?
How to Reset the Passlock System on GM Cars
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
How can I bypass passlock?
Thankfully this is an easy fix.
- Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
- Look at the dashboard and locate the theft system light.
- Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.
Does passlock disable fuel pump?
The factory Passlock anti-theft system immobilizes our cars by simply disabling the fuel pump from running. No fuel pressure = no car stealing. Check your car this way; use the remote keyfob to LOCK the car and observe the speedo or tach for the security indicator to start flashing or turn on.
How do I know if my passlock is activated?
Most PASSLock-equipped vehicles have a telltale indicator in the instrument panel. When a PASSLock-equipped vehicle is being started, the instrument panel warning light for PASSLock remains on until the engine starts.
Where is PassLock sensor located?
The Passlock III system uses a transponder located under the plastic covering of the key. In most cases, these keys are stamped “PK3” on the metal blade near the plastic covering.
How do I know if my car is in anti theft mode?
If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.