How do you program a key fob for a Pontiac Grand Am?

How do you program a key fob for a Pontiac Grand Am?

Let go of the unlock button and listen for the vehicle to beep three times to signify it has entered programming mode. Push both the unlock and lock buttons on the remote control at the same time and hold until the vehicle beeps twice. Repeat this for any additional remotes.

Can I program my own keyless entry remote?

Like new keyless entry systems, used keyless entry systems can be programmed or reprogrammed in just minutes from the driver’s seat. Using your keyless remote and your ignition key, programming will have you ready to use this safety and convenience feature right away.

How do you program a key fob for a 2001 Pontiac Grand Am?

Press and hold the LOCK and the UNLOCK buttons simultaneously on the first transmitter for approximately 15 seconds. The Power Locks should cycle to confirm programming of the first fob is complete. If you are programming more than one transmitter, repeat the previous step to program up to four transmitters.

How do you program a keyless remote for a 2002 Pontiac Grand Am?

Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. Repeat step 8 in order to program each additional transmitter. Remove the ignition key from the ignition lock cylinder. Install the MALL PGM fuse back into the fuse panel.

How do you program a key fob for a 2005 Pontiac Grand Am?

Key Pairing : Instructions

  1. Insert a master/working key and switch the ignition on.
  2. Wait for the security/immobilizer light to go out. Switch ignition off and remove key.
  3. Quickly insert a UN-paired key and switch the ignition on.
  4. Wait for the security/immobilizer light to go out.
  5. The key is now paired.

How do you program a Bonneville key fob?

PRESS and HOLD both the LOCK and UNLOCK buttons together on the first remote to be programmed. After about 15 seconds, the vehicle will respond by cycling the door locks LOCK / UNLOCK to signal successful programming of the remote. RELEASE the buttons on the remote.

How do you program a key fob for a 2004 Pontiac Grand Am?

Press the DISP button to start programming. When the message PUSH FOB flashes, press and hold the LOCK andUNLOCK buttons on the first transmitter at the same time for 15 seconds. A chime will be heard to verify the transmitter islearned.

How do you program a key fob for a 2004 Pontiac Grand Prix?

Put your key into the ignition, and turn to “ACC.” Turn the key on and off within a second. Open and close the driver’s door and listen for the chime that indicates you are in programming mode. Press and hold the LOCK and UNLOCK buttons for 14 seconds, listening for the chime. Wait 14 seconds for the second chime.

How do you reset a Grand Prix computer?

turn the key on for 10 minutes or more if you want. then you will see the security light stop blinking, then you turn the key off. you repeat this three times then it should start. Good luck.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top