What size is the axle nut on a 2006 Pontiac g6?
36mm
What size socket fits the axle nut?
This 36mm axle nut socket is extra deep to fit various axle lengths and can be used to remove or install axle nuts on front wheel drive vehicles.
What is the torque specs for a axle nut?
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200 ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of 300 ft-lbs.
How do I stop my axle from spinning?
How do I stop the axle from turning. stick a fairly thick screw driver inside one of the vent holes in the rotor, and the caliper will stop it from turning depending on the direction ya want it to go.
Do you need a torque wrench for axle nut?
The axle nut needs to be torqued to 180 ft lbs. You can still tighten the wheel nuts evenly without a torque wrench. . 21-May-2021 . I used the gun to torque the nut but I have no way of knowing how much torque it actually applied.
Do you need to torque axle nut?
Proper torque secures the axle nut and keeps the proper load on the hub assembly. Proper torque is critical for two reasons. First, it secures the axle nut so it won’t work itself loose and back off. Second, the proper torque keeps the correct load on a hub assembly needed for longer bearing life.
Should you use a new axle nut?
Don’t Reuse the Old Nut In these applications, a new nut must always be used when installing a hub. Reuse of the old nut could potentially cause the nut to loosen during vehicle operation.
Do you put Loctite on axle nut?
They will also tell you that if you do reuse the nut, you should use Loctite. The short answer is that everything on the suspension and driveline gets blue Loctite unless there is a specific reason to do otherwise.
Does axle nut need to be replaced?
Technically you are supposed to replace the nut, however, it can be thread locked. If you removed the ball joint bolts, those definitely need replacing!
Why can’t you reuse a spindle nut?
Registered. Eh, you’re not supposed to reuse them because they have a plastic washer thingy inside them where the threads cut grooves into the nut and kind locks them in place. Most of the time your get one with the hub unit.
Are axle nuts one time use?
However, a toplock nut can only be installed one way, since the deformed end can’t engage the threads. Whichever style is on your vehicle, make sure you buy a new nut after removing the old one. The old nut will not hold the proper torque a second time.
Can you reuse a hub nut?
The stakeable hub nuts shouldn’t be reused, but can be in an emergency provided that they are not damaged when “unstaked”. If there are any breaks, tears, or similar in the collar that you stake, you must replace them.
Can you reuse a staked axle nut?
You can use it, just try not to damage the stakes area too bad, since you will have to restake it when you go back together.
What happens if wheel bearing is loose?
If a wheel bearing is missing, it is not recommended you drive the vehicle at all as the wheel can fall off entirely while the vehicle is in motion. The wheel bearing is an essential part in keeping the wheel attached to your car, so without it, the wheel has nothing to hold it on.