How do you reset the oil light on a 2008 Volvo S40?

How do you reset the oil light on a 2008 Volvo S40?

Oil Change Light Reset Volvo S40 2005 2006 2007 2008 2009 2010 2011

1. With ignition off, press and hold the trip odometer “RESET” button and turn the ignition to the “RUN” position within 2 seconds.
2. Continue to hold button until original value has been reset.

How do you reset the oil light on a Volvo S40?

Step 1: Reset Maintenance Message

1. Press and hold trip reset button,
2. turn on the ignition,
3. wait for the yellow warning light to start blinking,
4. release the button and wait for confirmations sound,
5. turn off the ignition,
6. turn the ignition back on to check if the service message is gone.

How do I reset my Volvo crash?

Remove the remote control key and open the driver’s door. If a message is now shown to the effect that the ignition is on, press the start button. Then close the door and reinsert the remote control key. The car’s electronics will now try to reset themselves to normal mode.

How do you reset the service light on a 2011 Volvo S40?

Turn ignition to position I (ON.) Press and hold in the reset button for the trip odometer. Turn the key to position II within 2 seconds, while continuing to press trip odometer reset button. Hold the reset button for the trip odometer pressed in until the original value has been reset.

How do you reset the maintenance light on a 2010 Volvo S40?

How to Reset the Time for Maintenance Light on a Volvo S40

1. Press in the trip odometer reset knob. Hold the knob down.
2. Turn the ignition switch to the “II” position. Do not start the engine.
3. Hold the odometer knob down for about 30 seconds until the maintenance light blinks. Release the trip odometer knob.

What does engine system service required mean?

The Engine System Service Required is a service interval indicator. The engine check light coming on will mean you have a fault. You can simply re-set the Engine System Service Required by carrying out a simply re-set. Button A is located at the bottom and to the left of your speedo.

What is Dstc service required?

The system is temporarily reduced due to excessive brake disc temperature. – The function is reactivated automatically when the brakes have cooled. DSTC Service required. The system is disengaged. Stop the car in a safe place, switch off the engine and start it again.

What does engine system service required mean on my Volvo?

“Engine system service required” indicates a stored fault code which, as stated above, could be very minor or very expensive or anything in between. The only way to know is to het the codes read with proper Volvo diagnostic gear, generic code readers aren`t usually much help on these.

What does check engine light mean on Volvo?

If the check engine light in your Volvo starts flashing, that means that the problem needs sudden attention and your Volvo should be brought in today. This blinking light constantly indicates a strict engine misfire allowing unused fuel to be discarded into the exhaust system. …

Why is my emission control system light on?

If your light is on, it typically means the car’s emissions control system is faulty, and the vehicle is polluting the air beyond allowable federal standards. A vehicle in this condition would fail an emissions inspection or smog check.

Can I still drive my car with the engine light on?

Can you drive a car with the engine light on? It’s okay to drive for a few miles, but be sure to schedule an inspection of the engine as soon as possible. If the check engine light comes on while you’re driving, don’t panic! Pay attention and see if the car is driving any differently than normal.

What to do if check engine light is on?

What to Do About the Check Engine Light

1. Look for a serious problem that requires immediate attention. Check your dashboard gauges and lights for indications of low oil pressure or overheating.
2. Try tightening your gas cap.
3. Reduce speed and load.
4. Use built-in diagnostic services, if available.