How do you remove the rear wheel on a Honda Shadow?

How do you remove the rear wheel on a Honda Shadow?

Center stand the motorcycle or lift the rear wheel, remove the axle bolt, knock out the spacer, and slide the brake panel out of the way. Now the wheel is resting only on a splined shaft. Grab the wheel and gently slide it away from the final drive ( off the splined shaft ) and roll it out the back of the wheel well.

How do you fix a punctured rear wheel on a bike?

Here’s our step by step guide to fixing a puncture

1. Step 1: remove the wheel from the frame.
2. Step 2: remove the valve cap and retaining nut.
3. Step 3: use tyre levers to loosen the tyre.
4. Step 4: remove the tyre.
5. Step 5: check the tyre for debris.
6. Step 6: put a little air in the tube.

Can you remove bike cassette without special tools?

A direct answer to your question is: If you use anything other than the correct tool, you risk damaging your cassette or cassette lockring. So, No, it’s not possible.

What tools do I need to remove a cassette?

The lockring is designed to hold the cogs of the cassette in place on the hub. In order to remove and replace your cassette, you need to unscrew this lockring. You’ll need three tools to do this: a chain whip, a cassette lockring remover and a large adjustable crescent wrench.

How do you remove a Sunrace lock?

To remove the cassette, hold it from spinning using a chain whip. Insert the lockring tool (use the FR-5 series), and turn the tool counter-clockwise. The locking ring will unthread from the freehub and the cassette will lift upward. To install the cassette, lubricate the threads inside the cassette stack.

How do I remove a freehub body?

The axle is independent of the freehub.

1. Remove set screw from side of drive side locknut.
2. Hold non-drive side cone with cone wrench. Loosen and remove drive side locknut.
3. Pull freehub to remove. Use care not to loose small parts. Note orientation of pawls as you remove freehub.