Are Chevy 350 heads interchangeable?
They are the same even with aftermarket heads. No matter which head goes where then accesory holes will poin the same way.
Are Chevy TBI heads good?
TBI heads are often talked down by people who are too lazy and/or ignorant to learn otherwise, don’t let it fool you though, they’re a very good stock casting. They outflow most production casting SBC heads on the exuast side, and they don’t lag too far behind on the intake side.
How much lift can stock TBI heads handle?
Specs on Stock TBI cam is . 050″ tappet lift (intake/exhaust) is 165/175; and maximum lift with 1.5:1 rocker ratio (intake/exhaust) is . 382/. 402.
How much horsepower does a stock 350 TBI have?
| Engine | L05 TBI 350/5.7L Goodwrench Engine |
|---|---|
| Horsepower | 200HP @ 4000RPM |
| Torque | 300FT/LBS @ 2800RPM |
| Compression Ratio | 9.3:1 |
| Block | 4-Bolt Main, 1-Pc Seal, 4.000″ Bore |
Can you put a carb on a vortec 350?
You can use a carb intake for vortec heads, just get an intake made for vortec heads. A regular chevy distributor will drop right in. Chances are you’ll need to run an electric fuel pump since your block is likely not drilled for a fuel pump pushrod.
Will a TBI intake fit vortec heads?
Chevrolet Performance Vortec Intake Manifolds with TBI These Vortec manifolds with TBI from Chevrolet Performance are designed for maximum horsepower with throttle body fuel injection and EGR usage. These manifolds will fit all Vortec-designed cylinder heads.
Can you put TBI heads on a Vortec 350?
That said, TBI can be adapted to a Vortec headed engine by using a GMPP or Edlebrock intake that bolts to Vortecs at one and and TBI at the other. But you would need to buy a TBI intake manifold to bolt up to the Vortec heads. You can’t by a spacer for the Vortec intake manifold.