Can you use 3/8 drywall wall?
It’s found in most homes on walls and ceilings. 3/8″: This size is thin and easier to bend, so it’s commonly used on curved surfaces or for covering existing drywall.
How far apart should drywall screws be on ceiling?
Conclusion. Drywall screws should be placed 12 to 16 inches apart, but the distance can vary. Place screws eight inches apart on edges and ceiling edges, and no more than 12 inches apart on the ceiling field.
Should I drywall over lath?
You can attach drywall directly to lath. If you’re remodeling an older home and you run into a plaster-and-lath wall, you can remove the plaster and install drywall over the laths. After securing the laths, you’ll install the panels in the same way you would install them on a new stud wall.
Should you remove lath before drywall?
As discussed above, this tends to leave voids in the stud spaces. The best—but messiest—way to update to drywall is to completely demolish the old walls, tearing out the plaster and lath all the way down to the studs, and then updating the wiring and insulation before installing new drywall panels.
Should I replace lath and plaster with drywall?
A: Yes, it’s expensive and messy, but your first thought is your best. To do the job properly you should strip all the plaster from the walls, leave the lath in place and cover it with 3/8 -inch drywall. Of the other two fixes you mention, the best by far is cutting out the damaged plaster and replastering the cracks.
Why do lath and plaster ceilings collapse?
Lath and plaster ceilings do not react well to vibration or water ingress. If enough of them snap off the weight cannot be supported and the ceiling collapses. Similarly, water from above soaks into the porous plaster and weakens the nibs.
How do you know if your ceiling is going to collapse?
a loud cracking sound in the ceiling; a sagging or dropping of the plasterboard sheeting and/or the cornice; and. visual cracking and/or small circles or blisters (nail pops) on the ceiling, which are a sign the plasterboard sheeting may be pulling away from the nails or screws.