What is statistical process control in manufacturing? Statistical Process Control (SPC) is an industry-standard methodology for measuring and controlling quality during the manufacturing process. Quality data in the form of Product or Process measurements are obtained in real-time during manufacturing. How do you use statistical process control? Implementing Statistical Process Control Select critical-to-quality (CTQ) product […]
How do I hide assignment grades in canvas?
How do I hide assignment grades in canvas? To hide assignment grades, click the Posted Visibility icon [1] and select the Hide Grades option [2]. Note: Students will be unable to view their grades until the assignment is posted. How do you hide assignments on Google classroom? Hide an Assignment Click CLASSES on the top […]
How do you find tangential acceleration?
How do you find tangential acceleration? It is equal to the product of angular acceleration α to the radius of the rotation. The tangential acceleration = radius of the rotation * its angular acceleration. It is always measured in radian per second square. Its dimensional formula is [T-2]. Does centripetal acceleration increase with radius? Centripetal […]
What does it mean when your car says tire pressure monitor fault?
What does it mean when your car says tire pressure monitor fault? The “tire pressure sensor fault” message is an indication that there is a problem with the tire pressure monitoring system (TPMS). If the tire is overinflated or underinflated, this could cause damage to the tire and/or hazardous driving conditions. What is the purpose […]
Why do we measure flue gases?
Why do we measure flue gases? Flue gas analysis will give you an indication of whether or not you are achieving maximum possible carbon combustion in your fuel. You can also analyse your flue gas in order to determine environmental impact and whether you are maintaining compliance with local emissions regulations. How is flue gas […]
Which of the following is not part of the NIMS management characteristic of chain of command?
Which of the following is not part of the NIMS management characteristic of chain of command? Restricts personnel from sharing information with each other is NOT part of the NIMS Management characteristic of Chain of Command. Restricts personnel from sharing information with each other is NOT part of the NIMS Management characteristic of Chain of […]
Why is it important to check around your vehicle before entering?
Why is it important to check around your vehicle before entering? You should walk around your car before the road test for the same reasons you should walk around your car before you drive it every time you drive it: to ensure there is nothing in the blind areas around the vehicle (such as children […]
What is the output frequency for a frequency division circuit that contains 12 flip flops with an input clock frequency of 20.48 MHz?
What is the output frequency for a frequency division circuit that contains 12 flip flops with an input clock frequency of 20.48 MHz? 12. Determine the output frequency for a frequency division circuit that contains 12 flip-flops with an input clock frequency of 20.48 MHz. Output Clock frequency = = 5000 i.e., 5 kHz. How […]
What kind of piping is used in an ammonia refrigeration system?
What kind of piping is used in an ammonia refrigeration system? Steel piping What is refrigeration copper tubing? Copper, used for refrigeration, is designated as ACR copper. Measure the inside and outside diameter of the end of the tube. The outside diameter of Type L is always 1/8-inch larger than the size marked on the […]
What is the input impedance of a common emitter amplifier?
What is the input impedance of a common emitter amplifier? around 1kΩ How do you test for impedance? To find the output impedance the output voltage is measured first with no load resistor, then with a fixed load (purely resistive). To measure the input impedance over a complete spectrum of frequencies, use the following circuit: […]