How do I change the battery in my four wheeler?

How do I change the battery in my four wheeler?

Removing and Replacing the ATV Battery

1. The first step is to remove the seat.
2. If your battery cables are bolted to the battery terminals, use a socket to remove the negative cable first then the positive.
3. There will be a retaining bar that secures the battery to the battery compartment.

How do you bypass the ignition on a four wheeler?

Bypass The Ignition On wire is sending power in, and the other wire sends power to the electrical box if the key is inserted. Telling the machine that it’s ok to start. Simply remove the ignition switch from the equation. You can disassemble the switch or just cut the two wires leading to it.

How do you start a four wheeler that won’t start?

If your ATV doesn’t crank at all when you’re trying to start it, there are a few basic things to look into.

1. Make sure the kill switch/run switch is in the “ON” or “RUN” position.
2. Make sure the ATV is in “Park” or Neutral.
3. Make sure the battery is charged.
4. Check the main fuse.
5. Make sure the solenoid is getting power.

What would cause a 4 wheeler not to start?

There could be a number of reasons the engine isn’t getting enough fuel to start and stay running. The most common reasons have to do with the fuel pump or the carburetor. If you have a fuel injected motor, you may just need to clean the injectors to get it running smoothly again.

How do I know if my ATV engine is seized?

Here is how to tell if your ATV’s engine has seized: If the engine doesn’t budge and gives a ‘click’ sound on attempting to start it electrically or when the crankshaft doesn’t turn when you manually try to turn it using a rachet on the crank bolt, you should be certain that your ATV engine has seized.

Will a seized engine turn over?

What does a seized engine mean? A seized engine means the electronics in your vehicle may still work (i.e. the radio, A/C, etc.) but the engine itself will not turn over. Instead, you may hear a knocking or clunking sound.

How do you Unseize a Polaris engine?

Pull the plastics… pull the gas tank… remove the plug… put a little tranny fluid in plug hole….let it sit for 3-4 hours…then try and turn the flywheel forward and back…go easy…..it may just have surface rust in the cylinder from sitting and such…

How do I get water out of my ATV engine?

Take the plugs out of the engine and turn the motor over to force any water in the cylinder out. Water in other parts of the engine will come out with the oil. Add oil to the engine and turn it over again, without the plugs in.

How do you ruin a four wheeler?

By avoiding these nine ways to ultimately ruin your ATV, you can ensure you and your ATV can live a long, happy life together.

1. Never clean the air filter.
2. Ride with a clogged radiator.
3. Let the fuel go bad.
4. Never change the oil.
5. Never tighten the bolts.
6. Never grease it.
7. Submerge it in water.
8. Crash it.

How do you tell if a four wheeler is flooded?

If your ATV is dry and not been out running through rivers and streams, attempt to start it a couple times with the choke on and giving it some gas. If it turns over, but won’t start, it might be flooded. This is when too much gas is in the engine.

Can you put dry gas in a four wheeler?

Yep. Put good gas in there, start it up at least every month or so. Don’t overthink it.

What is the best gas for ATV?

The best solution for worry-free operation in small engines is non-ethanol gas. Sometimes called pure gas or clear gas, non-ethanol gas comes with an octane rating of 88 and that will make ATV engines very happy. It takes the worry out of storage and is safe on engine parts.