How do I engage my PTO John Deere?
PTO can be engaged or disengaged without operating clutch. Push down and forward on PTO switch (A or B) to engage PTO clutch. Pull back PTO switch (A or B) to disengage clutch.
Where is the PTO switch on a John Deere mower?
Most John Deere lawn mowers are equipped with an electric PTO (Power Take Off). The PTO is the mechanism that turns on the blades located under the mower deck. The PTO works off of a 12-volt system. The electric clutch is operated by a switch located on the dashboard of the lawn mower.
How does a PTO work on a lawn mower?
Driven by electricity provided by the mower’s 12-volt battery, the PTO clutch engages when its solenoid receives an electric spark. The PTO pulley is attached to the clutch and guides the belt that connects to the engine crankshaft pulley and rotates the blades of the mower that are located under the mower’s deck.
Where is the PTO on a riding lawn mower?
The PTO clutch is mounted under the tractor or mower beside the power drive shaft, which is also vertically aligned. It is connected to the blade shaft, and when it spins, the blade spins too. There is a belt that is attached to the drive shaft and PTO clutch pulley.
Why won’t my mower blades engage?
Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also. When you are trying to process too much grass/leaves they could pack up under your deck and push off your belt.
Why won’t my Craftsman mower blades engage?
Common solutions for: Craftsman Lawn mower blades won’t engage. If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Why does my lawn mower stall when I engage the blades?
If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged. The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged.
Why does my riding mower keep stalling?
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
What causes a lawn mower engine to rev up and down?
A lawnmower that hunts and surges may be experiencing something as simple as an airflow issue. If the air that the engine requires to run is blocked, especially sporadically, it can cause the engine to slow down. When the blockage moves or clears, the engine may suddenly rev up in response.
Why does my truck die when I rev it up?
Some common reasons for motor vehicle stalls include: A fuel mixture that isn’t rich enough (this is usually the cause of cold stalling and intermittent stalling) A faulty fuel pump, alternator or EGR valve. A dead battery.
Why is my car stalling when I push the gas?
The car will stall if the valve is too clogged or when it finally fails. If, while holding the accelerator pedal down, a small amount of pressure keeps the car running at a stop, the idle control valve may require attention. In most late model cars, this problem will usually trigger the Check Engine light.