How do I get my 1999 Ford Ranger out of theft mode?

How do I get my 1999 Ford Ranger out of theft mode?

To reset the anti-theft on the vehicle You will need to first get into the vehicle and shut the doors. With the doors shut You want to put the key into the ignition slot and turn it on. Once You have turned it on You will then want to turn it back to the off position.

How do you turn off the alarm on a Ford Ranger?

Turn off the securilock feature by turning the ignition key to the “off” position. Turn it to the “on” position. Notice that the securilock indicator on the instrument panel will light up for three seconds then turn off.

What is a rap module?

The RAP module is the older method of keyless entry and perimeter anti-theft, spanning a time line of the late ’90s to early 2000s.

How do you reset the check engine light on a 1998 Ford Ranger?

To reset the check engine light on your ford ranger first turn off the car. Then, open the hood and disable the battery cable negative terminal from the battery, and leave it off for 30 seconds. Reconnect the battery cable negative terminal, and your check engine light should have reset.

How do you reset the check engine light on a 2001 Ford Ranger?

How to Reset Trouble Codes on a Ford Ranger

1. Put the vehicle in park and turn off the ignition.
2. Raise the hood and locate the car battery.
3. Place the adjustable wrench on the bolt securing the negative battery cable to the negative terminal on the car’s battery.
4. Adjust the wrench until it fits snugly around the bolt.

How do I reset my Ford Ranger?

HOW TO RESET: FORD RANGER

1. Make sure the Engine and Ignition is OFF.
2. Press Both The Brake And Accelerator Pedals At The Same Time Turn the IGNITION ON.
3. Release The Brake And Gas Pedals.
4. Turn Ignition Off. Oil Reset Is Complete.

How often should a Ford Ranger be serviced?

Ford Ranger Maintenance Every Six Months.

How do you reset the BCM on a Ford Ranger?

Depending on the year Your Ranger is You may be able to reset it by disconnecting the negative battery terminal and leaving the truck to sit for 10-15 minutes.

Can you bypass body control module?

If you cut that wire and ground the end that goes into the relay it will bypass the bcm’s control over it. Yes. Potential causes of a malfunctioning BCM include hard impact collisions, loose wiring harnesses, shorting of wires, excessive heat from the engine, and damaged sensors.