How do I get my car out of anti-theft mode?

How do I get my car out of anti-theft mode?

Method 3: Insert the key into your car’s door Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

How do I turn off anti-theft system?

Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.

How do you reset the anti-theft system on a 1996 Pontiac Grand Am?

How do i reset security code?

1. Perform a security system relearn.
2. Let the vehicle sit for more than 10 minutes with the key off.
3. Attempt to start the engine, leave the key in the run position monitoring the security system indicator.
4. After 10 minutes, the security indicator will change state.

How do you reset the security system on a 2008 Pontiac G6?

3. Turn the G6 key in your ignition from “On” to “Off” while holding the “Lock” button, and do two more cycles of “On” and “Off” in quick succession.

How do you reset the anti theft system on a Pontiac G6?

How do you reset the anti theft system on a 2005 Pontiac G6? Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON (vehicle will not start). Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.

Where is the reset button on Pontiac G6?

Where is the reset button on Pontiac G6? the ‘set/ reset ‘ button is the bottom left button that is an arrow pointing left.

How do you start a car with a broken ignition?

Find the solenoid and connect it to the positive terminal of the battery. Unplug the ignition wiring from the solenoid. With the help of a screwdriver, connect the solenoid to the post where the ignition switch connects. This will activate the solenoid and the vehicle should startup.