How do I know if my shock collar is working?

How do I know if my shock collar is working?

Touch both points on the collar while it is ticking or beeping. If you do not feel a shock, then there may be a problem with the receiver collar. Make sure you touch both points on the receiver at the same time when you hear the collar beeping. It will tell you definitively that the fence is or is not working.

How do I turn on my petsafe collar?

Turning the Receiver Collar ON

1. Press and hold the Mode Button continuously for 2 seconds.
2. The green light will light up briefly and you will hear two tones chime.
3. When the Receiver Collar is turned on without a programmed boundary, the Receiver Collar will perform the ReadyTest® sequence, two chimes and then shut down.

How do I reset my PetSafe wireless transmitter?

How do I re-synchronize my wireless system?

1. Remove the receiver collar from your pet.
2. Remove the battery from the receiver collar.
3. At the transmitter, move the boundary switch from the low to the high position.
4. Slowly adjust the boundary control dial up to #8, down to #1 and then back to the #4 position.

Why is my PetSafe wireless transmitter beeping?

If the transmitter still beeps / no loop light on Short Loop Test, please contact our Customer Care Center to discuss having unit replaced. If the transmitter is functioning properly on the Short Loop Test, you have a break in your boundary wire.

Why is my invisible fence not working?

Replace the Batteries Some invisible pet fences include a battery tester with the fence system. Place this on the collar and walk past the boundary wire. If you hear the warning, but no light flashes, replace the battery. If you don’t have a tester, replace the battery and carry the collar past the boundary.

How do I change my petsafe stay and play?

Press and hold the Mode Button continuously for 5 seconds (3B). The green or yellow or red Receiver Indicator Light will turn ON for 5 seconds (3C) to indicate battery status, followed by the red Receiver Indicator Light flashing the Static Correction Level Settings.

Does the PetSafe wireless fence shock?

Risk of electric shock. Use the Fence Transmitter indoors in dry location only. This PetSafe® Wireless Pet Containment System® is NOT a solid barrier. The system is designed to act as a deterrent to remind pets by Static Correction to remain in the boundary established.

Can you adjust PetSafe wireless fence?

Facing away from the transmitter, hold the receiver collar at the edge of the desired pet area. Measure the shortest distance from the desired boundary zone to the transmitter. If the receiver collar beeps before or after the desired boundary zone, return to the transmitter and adjust the boundary control dial.

How long do PetSafe collars last?

It should last 3-4 years.

How do you reprogram an invisible fence collar?

The collar will beep or blink in series to indicate the new shock level. Press the button again within 5 seconds to raise the level once more. Continue until the collar indicates it is at the correction level you desire. To lower the correction level, continue pressing the button; the level will cycle back to 1.

How do I make my invisible fence collar stronger?

How to Change the Strength of an Invisible Fence

1. Push the button on the receiver. A light on the receiver will flash.
2. Adjust the distance from the boundary wire to trigger a warning alarm. Most transmitter boxes have a knob or lever to use to change the distance.
3. Change the metal prongs on the receiver.