How do I program my Hyundai HomeLink?

How do I program my Hyundai HomeLink?

Hyundai HomeLink First-Time Set-Up Guide

1. Hold garage door remote within 1-3 inches of the HomeLink buttons.
2. Simultaneously press and hold the open/close button on your garage door remote and the HomeLink button you want to program.
3. Hold both buttons until HomeLink indicator light flashes.

How do I program my second HomeLink button?

Programming a Brand New HomeLink Using both hands, simultaneously press and hold both the desired HomeLink button and garage door remote button. DO NOT release until the HomeLink indicator light flashes slowly and then changes to solid or rapidly flashing.

How do I reprogram my HomeLink garage door opener?

Reprogramming a Single HomeLink Button:

1. Press and hold the desired HomeLink button.
2. Continue holding the HomeLink button for about 20 seconds, and the HomeLink indicator light will start slowly flashing.
3. Press and hold the programmed HomeLink button and observe the indicator light.

How do I program HomeLink without opener?

You only need to hold the remote up to the HomeLink button you want to program and push both that button and the remote button at the same time. Hold them until you see the LED on the in-car remote begin to flash rapidly.

Why can’t I program my HomeLink?

I can’t program my HomeLink. First try the following troubleshooting tips: Cycle the handheld transmitter during programming: Press and hold the HomeLink button while you press and release the handheld transmitter every 2 seconds until the indicator light changes from a slow blink to a rapid flash.

Why is my HomeLink light red?

Step 1: If you press your chosen button and the LED light is red, then your remote is already set to program and you may skip the rest of step 1.

How do you sync overhead doors to your car?

Press and hold the two outside buttons on the HomeLink ® system until the LED starts to blink, release buttons. While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed HomeLink ® button 4 times. (Or until the garage door operates).

Why is my garage door keypad blinking?

When the garage door opener is in lock mode, the LED light on the door control will constantly flash and the hand held remote controls will not operate your garage door opener. To take the unit out of lock mode, press and hold the lock button for two seconds. Note: lock button may be located under push button cover.