How do I reset my Bell Satellite Receiver?

How do I reset my Bell Satellite Receiver?

To reset your receiver to the factory default settings:

1. Press MENU on your remote control.
2. Select System Setup.
3. Select Factory Defaults.
4. A pop-up message will appear to confirm that you want to reset your receiver to the factory default settings.
5. Select Yes.

Why is my bell receiver not working?

Unplug the power cable on the back of the Fibe TV receiver. Wait 10 seconds. Wait approximately five minutes for the Fibe TV receiver to restart. Once the Fibe TV receiver has restarted, check to see if your TV picture has returned and the Fibe TV receiver responds to the remote control.

How do I reboot my Bell Fibe receiver?

Reboot your receiver

1. Press and hold-down the green POWER button on the front of your TV receiver for 5 seconds (until the red, green, and blue lights come on).
2. Wait a few minutes for the reboot to take place.
3. Once the reboot completes, content from the channel that you last viewed appears.

Why is my Bell Satellite not working?

Try resetting your receiver by pressing and holding the POWER button on your receiver for at least five seconds until it resets. If you’re still having issues, please contact us. Try resetting your receiver by pressing and holding the POWER button on your receiver for at least five seconds until it resets.

How do I reconnect my satellite signal?

Connecting Your Satellite Dish to Your TV

1. Connect one end of the coaxial cable to the back of your satellite dish labeled “LNB”
2. Connect the other end of the coaxial cable to your satellite receiver in the port marked “Sat in”.
3. Next, connect one end of the HDMI cable to the ‘output’ port in the back of the satellite.

How do I fix my Bell satellite dish?

My Bell Satellite TV signal fluctuates

1. Restart the receiver. Press and hold the Power button on the front of the receiver for 5 seconds and wait for the receiver to turn on.
2. Check the power inserter.
3. Check the cables.

What do you do if you have no satellite signal?

“No Satellite Signal” – What to do You need to either remove the power cord or turn off the power at the wall, wait ten seconds and then turn it on again. The box can take up to two minutes to fully initialise again so don’t keep trying to turn it on repeatedly during this time, you may extend the restart process.