How do I reset my GE refrigerator ice maker?

How do I reset my GE refrigerator ice maker?

How do I reset my GE ice maker?

1. Locate the shut-off switch on the front of the GE refrigerator ice maker and turn the switch off, leaving it off for at least 30 seconds.
2. Turn the switch back on and locate the feeler arm on the ice maker.
3. Push the feeler arm up three times quickly to reset the ice maker.

Why did my GE refrigerator stop making ice?

If the temperature in the freezer is too warm, ice cubes will take longer to form or may not form at all. Try adjusting the freezer temperature a little lower. A low food load in the freezer can affect the production of ice.

How do I test my GE ice maker?

The test will consist of the following sequence:

1. Turn on the motor until it reaches home position.
2. Turn on the water valve for 1/2 second.
3. Turn on the heater for 1/2 second.
4. Verify that the feeler arm was in the ‘in’ and then the ‘out’ position.

How do you force a GE ice maker to cycle?

How to Force an Ice Maker to Cycle

1. Open the freezer door to remove the ice bin from below the ice maker.
2. Empty the ice from the bin.
3. Press the ice maker toggle switch to the “On” setting if it is not already activated.
4. Pop off the front cover of the ice maker with the tip of a flat-blade screwdriver.

Where is the ice maker switch on a GE refrigerator?

For these refrigerator models, you turn the icemaker ON and OFF using the control panel on the fridge. ON/OFF Toggle Switch: This icemaker design has an ON/OFF switch similar to a light or power switch. ON is at the top of the toggle switch while OFF is at the bottom of the toggle switch.

What would cause an ice maker to stop working?

Cause: A common cause for a clog is frozen water in the line. Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).

How do you unfreeze a GE ice maker?

Apply heat with a hairdryer to the ice maker fill tube, which is usually a white, rubber-like hose. Hold the nozzle of the hairdryer at the front of the ice maker so that the heat will blast into the fill line. Set the hairdryer to its lowest heat setting to avoid melting the plastic lines and parts of the ice maker.

How do I Unjam my ice maker?

How to Fix Ice Not Ejecting from Ice Maker

1. Empty the Ice Bucket. The first place to start is your ice bucket.
2. Reset the Ice Maker Software.
3. Reset Ice Maker Hardware.
4. Break Up Ice Jam in Chute.
5. Release the Ice Ejector Paddle.
6. Replace the Ice Ejector Motor or Gears.
7. Melt the Ice Mold Tray.

Why is my ice maker freezing up?

A refrigerator ice maker that freezes up can be caused by a frozen ice maker fill tube, faulty water inlet valve, too low freezer temperature setting, or a water filter that needs replacing. First, locate the water supply to your ice maker and turn off the water supply via the shut off valve.