How do I reset my Weiser keypad lock?

How do I reset my Weiser keypad lock?

Weiser Lock reset:

1. Remove the battery cover using the Allen key.
2. Remove the battery pack.
3. Press and hold the program button while reinserting the battery pack.
4. Hold the program button for 30 seconds until the status LED flashes red.
5. Press the program button again.

How do you reprogram a Weiser keypad?

Note: Programming instructions can also be found on interior of lock.

1. a. Press the program button on the interior unit once.
2. b. Enter in 4 to 8 digit code onto the keypad.
3. c. Press the “LOCK” button to save code.
4. d.
5. a. Press the program button on the interior unit twice.
6. b.
7. c.
8. d.

How do you reprogram a SmartCode door lock?

How to restore default settings on my SmartCode lever? Perform a factory reset

1. Remove battery pack.
2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red.
3. Press the Program button once more.

How do you clear the code on a Kwikset lock?

Delete A User Code:

1. Make sure the door is open.
2. If you have not enabled a programming code, press and release the program button. You will hear two beeps.
3. Press 2 to delete a user code.
4. Press Kwikset.
5. Enter the user code you wish to delete.
6. Enter the user code again.
7. Press Kwikset.

How do you enter a code on a Kwikset lock?

How do I add/delete a user code on my Powerbolt 2?

1. Make sure the lock is unlocked and the door is open.
2. Enter your Mastercode – for new install, default is 0-0-0-0.
3. Press the lock button.
4. Press 1.
5. Press the lock button.
6. Enter a new User Code.
7. Press the lock button.
8. Test the code: While your door is open, lock it.

How do I reset the master code on a Kwikset 913?

How do I program my SmartCode 913 lock?

1. Open the door.
2. Remove battery cover.
3. Press the program button once.
4. Enter new user code.
5. Press lock button.
6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do you change the 4 digit code on a Kwikset keypad lock?

Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 – 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once.