How do I reset the radio Wait code on my BMW?

How do I reset the radio Wait code on my BMW?

You have to leave the car in the ‘ON’ position where the accessories are on with the radio on displaying CODE WAIT for 90minutes. It will then reset to CODE —– where you can enter the code. If the code he gave you doesn’t work, get them to look it up again.

How do I unlock my BMW radio code?

How to Locate a BMW Radio Code

1. Insert your car key into the ignition, leaving it in the “off” position.
2. Depress and hold the “M” button on your radio.
3. Turn the car key to the “on” position and turn on the radio with the “M” button remaining depressed.
4. Write down the serial number that appears on your radio’s display.

How do I reset my radio after replacing my battery?

Syncing the Radio

1. Turn the ignition key to the “On” position, but don’t start the engine.
2. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.

Can dealers see cleared codes?

Originally Answered: Can a car diagnostic scanner see codes previously cleared by another scanner ? It depends on the scanner, and if the problem is reoccurring or not. But, usually, no. When codes are cleared on OBD 2 vehicles (after 1996) another code is set, however.

How long does it take for an engine code to clear?

If you are sure that you have fixed the problem causing the check engine light, the engine light will reset itself after 10-20 successful cycles, and as you can imagine – 10-20 successful cycles can take a lot of time. Therefore it’s much easier to reset the check engine light with an OBD2 scanner.

Will a check engine code clear itself?

Your vehicle’s check engine light will will reset by itself once the issue or problem has been repaired; this is true for most models. But the issue may be a bit more involved than simply resetting it. The issue may stem from your car having to run several cycles.

How long does clearing codes take?

Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results. You can use GOFAR to constantly monitor your car diagnostics.