How do I uninstall GM instrument cluster?
After removing the trim plate bezel simply remove the four ¼” screws holding the instrument cluster in place. Pull the cluster out and unplug the single wiring harness connection in the back. 2. Using a small flat-bladed tool, remove the bezel from the ignition switch cylinder.
How do I uninstall ve cluster?
Removing and Installing VE Instrument Clusters
- Pull the lower black trim downwards from the top of the trim, and disengage the three clips holing the top most part of the trim in place.
- Swing the lower black trim downwards, and disengage the back 3 clips to remove the trim from the vehicle.
How do I get rid of VY dash cluster?
Nothing easier with a VY. Just above the cluster there is 2 screws, remove them. Then pull the cluster surround out from the top. Remove the 2 screws holding the cluster in, and pull it out.
How do I remove the controls from my VZ steering wheel?
Take a small flat blade screwdriver and insert into the slots on the back of your wheel. There are 2 per side, once in turn the screwdriver whilst gently pulling the airbag towards you, you will feel the airbag come away slighty from the wheel.
How do you remove a VE cup holder?
It is just clipped in. Just pry the rear section up and work your way forwards. To refit, you just line it up and push the clips back in. The switches will lift up with the trim piece, so don’t just rip it out – there’s not a heap of play in the wiring, but enough to not worry you if you use a bit of caution.
How do you remove a seat from a VE Commodore?
How to Remove Commodore Seats
- Slide the front seats all the way back. Remove the plastic caps on the front of the tracks to gain access to the mounting bolts.
- Reach under the seat and unplug any cables connected to the bottom.
- Pivot the bottom of the rear seat forward, as if you were going to lay the seats down flat.
How do I remove the VZ gear stick?
2nd remove the gear boot and cut the cable tie off around the knob, slide it back lower down the shaft. now get a screwdriver and pry around the base of the gear knob and you will see underneath the black rubber, 4 blue clips, pry them out of the way. Now just simply lift the knob up and WOLLAH!
How do you remove a shifter from a VE Commodore?
You will need a small flatheaded screwdriver to unclip the button near the top of the knob, remove the button, and then find the screw that holds the knob backing in place. Remove the screw, remove the backing, and find the circlip that holds the knob in place. Remove the circlip, and pull the knob off from the shaft.
How do you remove a VF manual gear knob?
Pull the shift boot up – and there is a clip that holds the shift knob to the gear select shaft – remove the clip – and pull the knob upward – now you can remove the knob.
How do you remove Vy gear knob?
Remove all of your centre console, and unclip the leather gear stick boot. Up the top on the inside of the boot there’s a little rubber ring – chop that and your gear knob will come off easily.