How do I unlock my hot tub control panel?

How do I unlock my hot tub control panel?

To unlock the panel, press “Time”, “Jets 1” and then “Cool”. ML200, ML240, ML260, ML400, ML551 and ML554 keypads do not have the locking option if they are used as a main panel. If one of these keypads is used as an auxiliary panel, it locks when the main panel is locked.

What does loc mean on a hot tub?

LOC Hot tub control has been locked by pressing the DISPLAY, MODE and (up) button within 3 seconds. Press DISPLAY, MODE and (down) button within 3 seconds to unlock panel. HOLD Control Panel and remote panel are temporarily deactivated.

How do I get the temperature lock off my hot tub?

To deactivate the SPA LOCK, press the LIGHT minus (-) and TEMP minus (-) buttons at the same time and hold them down until the word SPA and the lock symbol are no longer illuminated on the display (approximately two seconds).

What is SPA lock?

The spa lock feature is designed to lock the control panel so others can’t mess with the lights, jets, and temperature settings. It’s a useful feature if you like things a certain way and are the only one using the hot tub on a regular basis.

Do hot tubs turn on automatically?

Hot tubs are designed to always be switched on and it’s more economical to keep the water hot than it is to heat it up from cold each time you want to use it.

How do you reset a hot spot in a hot tub?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

Why won’t my hot tub stop running?

One potential problem could be the tub’s thermostat timer. An incorrectly set timer can easily be rectified, but a faulty timer will need to be replaced or repaired by a hot tub professional. Another possibility is that the heating element of the hot tub has burned out. This, too, will cause the pump to run constantly.

Are hot tubs supposed to run all the time?

Yes, you should leave your hot tub on all of the time. Hot tubs are designed to always be switched on and it’s more economical to keep the water hot than it is to heat it up from cold each time you want to use it.

Should a hot tub circulation pump run all the time?

Should My Circulation Pump Be On All the Time? Many modern spas are designed so the water is circulated continuously, 24 hours a day. If this is the case, just make sure your pump runs quietly and constantly. Some automatic modes will run the pump continuously on low speed.

Is there a reset button on a hot tub pump?

A spa heater has a high-limit reset button. The spa’s pump and heater provide a soothing environment by circulating water through jets and increasing it to the bather’s desired temperature. A spa heater may need to be reset if it has tripped or stopped working.

How do you fix the error code on a hot tub?

DO NOT USE THE HOT TUB while these error codes are flashing as the water will be scalding hot.

1. Open the spa cover to allow excess heat to escape.
2. Clean the filter cartridge.
3. Check water levels.
4. Reset when hot tub has cooled.

How do you bypass a high limit switch on a hot tub?

The hot tub high limit switch is sometimes triggered when you’re refilling your hot tub and can be reset by pressing the large red button on your spa pack.

How do you reset a high limit switch?

How to Reset a Furnace Limit Switch

1. Locate your furnace’s heating duct.
2. Locate the white limit switch.
3. Look at each arm to identify the settings.
4. Identify the component (setting) located in between the two arms.
5. Set the temperature on the middle component to approximately 105 to 115 degrees Fahrenheit.

Can you bypass a limit switch?

1 Answer. Yes, you can bypass the high limit switch for testing. It’s as trivial to do as it sounds.