How do you drain a Ford Transit diesel?
Water from the fuel filter in the Ford transit is pretty simple job all You’ll need is a drain pan to catch the fluid. Crawl under the driver side just below the door and just behind the crossmember You’ll see a petcock valve. Rotate the valve counterclockwise to open it up, the water will begin to drip.
How do you bleed a Ford Transit fuel system?
Re: Bleeding fuel system The best way to bleed your fuel system, is to take the fuel filter out, and fill it to the brim with diesel. Nest get a friend to crack open the injectors one at a time, and then crank it over until the fuel comes out, and tighten the injectors up. She should then start straight away.
How do you start a transit van after running out of diesel?
Loosen off an injector pipe at the injector end and crank the engine over until it is squirting diesel out without air in it, tighten it back up and hey presto the van should crank over and start to fire. Give it a squirt of easy start down the air intake to help it pull the diesel through if you have got some handy.
How do you prime a diesel van?
Prime the fuel system by turning the ignition on (Run position) for 30 seconds, but do not start the engine. This allows the pump to prime the system. Turn the ignition off, and then crank it for 15 seconds. If it does not start, repeat the first task and this one until it starts (cycle the key).
How do you prime a transit van?
Connect the open end of the pipe to the pipe from the fuel filter to the fuel pump (so the priming pump is inline) and pump the primer until it is stiff then with the aid of an assistant have them crank the engine while you continue to pump the priming pump, this will force diesel into the fuel pump.
How do I bypass Immobiliser on Ford Transit Connect?
Enter the code to turn off the immobiliser To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to validate the digit and resume, replicate the procedure until you have entered the whole code.
Why will my Ford Transit not start?
The most common causes that hinders normal starting operation of your Transit Connect are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.
How do I reset my Ford Transit ECU?
Disconnect the leads to the battery for 20 minutes. Reconnect the lead to the battery. Then drive normally, accelerating steadily up to 4,000rpm through the gears if possible. This resets the ECU and it will then re-learn fuelling and other features.
How do I bypass my Ford immobilizer?
Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.
How do I reset my Ford S Max Immobiliser?
Turn off the engine and remove the key from the ignition. Press the “Lock” button on the smart key to lock your system and reset the immobilizer anti-theft system.