How do you drain the coolant on a Pontiac Grand Prix?

How do you drain the coolant on a Pontiac Grand Prix?

Move the Pontiac Grand Prix to a level area and set the parking brake. Twist the radiator cap one full turn. Place a bucket underneath the radiator and blow the drain plug. Loosen the drain plug and allow the old coolant to drain completely from the radiator into the bucket.

Where is the engine block drain plug?

The drain will be located on the rear of the block, near the bottom but not level with the oil pan. Typically they are located closer to the flywheel housing then the outside of the engine pan and will look like large bolts set into the block which are not holding anything in place.

Where do you drain radiator coolant?

1. STEP 1 – Safety first.
2. STEP 2 – Press down on the radiator cap, slowly turn it counter-clockwise until it hisses, wait until the.
3. STEP 3 – Place a large container under the drain valve at the bottom of the radiator.
4. STEP 4 – Loosen the drain valve and allow the coolant to completely drain out.

Can I flush my radiator myself?

Flush the Radiator Remove the radiator cap and pour distilled water into the radiator until full. Replace the cap, then start up the vehicle and let it run for 10 to 15 minutes. This will work the distilled water into the engine, flushing out any loose debris or corrosion along with the last of the old antifreeze.

Can I just add coolant without draining?

You cannot just keep adding coolant without ever flushing and changing it. Most cars need a flush and complete fluid change every 5 to 7 years.

Does the car need to be running when adding coolant?

Make sure your engine is off and cool, the vehicle is in Park or Neutral, and the parking brake is set. If your engine is cold, the coolant level should be up to the cold fill line. Loosen the reservoir cap just a little, then step back while the pressure releases.

How much coolant does my car need when empty?

Most car cooling systems hold around 5 liters and engine coolants are sold in 1 – 20 liters containers, so it’s easy to purchase the exact amount that you want. When empty and depending on the capacity of your car’s coolant, it should need around 5 liters of coolant fluid.

Will check engine light go off after adding coolant?

Putting coolant is an easy fix, and for your vehicle the check engine light could come on because of the thermostat not working properly or because of a sensor that went out. Further coolant leakages in the engine could cause other crucial components to blow up; it also leads to corrosion of engine parts.

Can low oil cause a check engine light to go on?

Low oil pressure: If your car is low on oil, it can cause your check engine light to go off. This is often shown in its own glowing light along with the check engine light on the dashboard.

How often are you supposed to put coolant in your car?

every 30,000 miles

What happens if you put too much coolant in your car?

Coolant expands as it heats and contracts when it cools. The extra space prevents damage to your engine and hoses. In worst case scenarios, overfilling your antifreeze tank can lead to electrical damage if overflow comes into contact with engine wiring.

Can you fill your coolant with water?

Your car’s cooling system needs coolant to keep it from overheating. Although water can be added to the radiator for this purpose, it’s preferable to add a mixture of coolant and water because plain water can boil before the proper coolant will boil, causing your engine to overheat [source: pontiac].

How long does coolant last in a car?

Depending on the vehicle and the coolant, the average time between flushes is two years or 30,000 miles for silicated coolants and up to five years or 100,000 miles for an extended drain coolant. You can tell which type of coolant you have by the color.