How do you engage a John Deere mower deck?

How do you engage a John Deere mower deck?

How to Engage Lawn Mower Blades on a John Deere

1. Turn the key to the “on” position, advance the throttle to half speed and allow the engine to warm up for 2 minutes.
2. Lower the mower to the desired cutting height.
3. Engage the mower blades; push the lever to the right of the steering wheel all the way forward.

How do you engage PTO on a John Deere tractor?

PTO can be engaged or disengaged without operating clutch. Push down and forward on PTO switch (A or B) to engage PTO clutch. Pull back PTO switch (A or B) to disengage clutch.

How do you remove the mower deck on a John Deere LT155?

You don’t need special tools or advanced knowledge of the LT155 to remove the mower deck.

1. Remove the spark plug wire to prevent the mower from starting.
2. Locate the lift links on the mower deck.
3. Support the mower deck with a length of 2-by-4 lumber.
4. Locate the cotter pin in the mounting bracket near each lift link.

Should a mower deck be level?

Level the mower deck to ensure grass cutting height is even across the width of the deck. This will help ensure a smooth and seamless side-by-side blend between each row of freshly cut grass.

Where should mower deck wheels be set at?

Mower deck gauge wheels should be properly adjusted to prevent scalping grass on uneven terrain. The bottom of the wheels should sit approximately 1/8-1/2 of an inch from the ground, depending on your cutting height.

Do I need anti scalp wheels?

Cutting your lawn down to low is called scalping which is bad. The use of anti-scalping wheels will help to control the height of your cutting deck, give you a more even mow keeping the height set at your choice and stop you from scalping the lawn giving it the dead look.

Can I add wheels to my mower deck?

It all depends. A lot of cheap mowers like MTD have decks that are not designed to float, wiggle the deck by hand to see if the attachment system will allow any movement. If it is totally rigid then something will get bent or break when you put wheels on, forceing it to move.

What are the wheels on a mowing deck for?

What Are Deck Wheels For? Deck wheels aren’t the same as the wheels you see on the ground. These are wheels that help ensure that your mower doesn’t scalp your lawn. So, if you see them touching the ground, chances are high that you could end up with a seriously short lawn…or ugly bald patches.

Why is my mower cutting lower on one side?

If the deck on your lawn tractor is lower on one side than the other, the result is an uneven cut. Leveling your tractor’s deck periodically smooths out your lawn. It only takes a few minutes and just a couple of common tools to level your lawn tractor deck.

Should lawn mower wheels be same height?

Lawn mower wheels should be the same height, sitting between 2.5 to 3.5 inches (6.4 to 8.9 cm). The reason that some mowers are tilted forward is that the deck is sloped, not the wheels. A tilted deck offers more control on flat surfaces, and it prevents grass clippings from blowing around the yard.

What is the best height to cut your lawn?

The ideal length of your lawn depends on your climate, but most experts agree you should keep your grass about three inches long, with the last cut of the season taking it down to between 1-1/4 inches to 1-1/2 inches in length.

How do you raise the height of a riding lawn mower?

How do you raise the height of a lawn mower? Pull the height adjustment lever outward toward the wheel on an electric mower. Move the lever to a higher number to the rear of the deck for a longer cutting height. Adjust the lever to the front of the deck to a lower number for a shorter cutting height.