How do you fix a gas fireplace insert?

How to Repair a Natural Gas Fireplace Insert

Step 1 – Turn off the Gas and Electricity.
Step 2 – Determine the Problem.
Step 3 – Fill the Crack or Holes.
Step 4 – Clean the Unit.
Step 5 – Try Relighting the Pilot Light.
Step 6 – Replace the Thermocouple.

How do you measure for a fireplace insert?

To determine the right size, measure the following: opening height; opening width; opening depth (top and bottom); rear width and the depth of the hearth (area in front of fireplace). LOCATION: A fireplace insert needs to be placed in an existing masonry or factory-built fireplace with a working chimney.

What is the standard size opening for a fireplace?

The standard fireplace opening averages between 24 – 36 inches wide, 24 – 29 inches high, and about 16 inches deep. The distance from the hearth to the fireplace damper should be about 37 inches. The rear of the firebox should be 11 – 19 inches wide and right at 14 inches high.

How is firebox opening measured?

Measure the width of the opening at the top and again at the bottom. We need the minimum and maximum width (A). It might be helpful to print this page and use Figure 1 for all your measurements. Next, measure the height of the opening from the hearth (where the enclosure will sit) to the top of the fireplace opening.

How much space do I need for a corner fireplace?

Be sure your fireplace location is at least 36 inches from any combustible wall that lacks protection. If you add a wall protector, you may be able to reduce the clearance to 12 inches. Also, you should plan for a non-combustible hearth extension on the front and side of the unit.

What does F stand for in floor plan?

FD — Floor drain. GM — Gas meter. HTR — Heater. HW — Hot water unit or tank. KIT — Kitchen.

What does P mean on a floor plan?

Pantry

Why are symbols used on drawings and plans?

Symbols are used on electrical drawings to simplify the drafting work for both the drafters and the workers interpreting the drawings.