How do you pull a steering wheel?
Look for threaded holes in the wheel hub assembly. These holes are designed to be used by the puller for removal. Attach the steering wheel puller using the appropriate bolts. As you slowly tighten the center bolt, it presses on the steering shaft, causing the puller body to lift, pulling the steering wheel with it.
What is a gear puller set?
Pullers are used to remove parts from a shaft. The puller legs are placed around the part, while the puller screw is tightened against the shaft, then tightened further to apply enough pressure for the puller to remove the part from the shaft.
What is a 3-jaw puller used for?
3-jaw – The most universal of pullers, the 3-jaw puller has three articulating arms that have both internal and external hooks. You can use them to remove gears, pulleys, wheel hubs, all kinds of hard to remove parts. They come in several sizes and are inexpensive.
How many types of pullers are there?
There are different types of pullers. For inside or outside use, separators and bearing puller. Three-armed pullers are mostly preferred to two-arm pullers because of providing more secure grip when pulling. Two-armed pullers are used in situations where space is limited.
What does a pitman arm puller do?
The Pitman arm is a steering component in an automobile or truck. As a linkage attached to the steering box (see recirculating ball) sector shaft, it converts the angular motion of the sector shaft into the linear motion needed to steer the wheels….How do you use a pitman arm puller?
| List Price: | $60.95 |
|---|---|
| You Save: | $19.56 (32%) |
How do you make a small gear puller?
Cheap and Simple Gear Puller
- Step 1: Cutting the Frame. You will need something to act as the frame for the puller.
- Step 2: Drill the Screw Hole.
- Step 3: Cutting the Shaft Slot.
- Step 4: Modifying the Screw.
- Step 5: Adding the Pin.
- Step 6: Assemble It and Test It Out!
- Step 7: Gear Pushing.
How do you remove a pulley without a pulley puller?
You can use a tool such as a pickle fork to remove the pulley and then rotate it a bit with a screwdriver. Do it again and again until the pulley is finally out.