How do you remove a Honda Civic steering wheel?

How do you remove a Honda Civic steering wheel?

Procedure

1. Park your Honda Civic on level ground.
2. Open the hood and disconnect the negative battery terminal.
3. Wait 15 minutes.
4. Remove the access panel on the bottom of the steering wheel and disconnect the airbag wires.
5. Loosen the airbag bolts on the side of the steering wheel.
6. Remove the airbag from the steering wheel.

How do you remove the steering wheel on a 1992 Honda Civic?

take out the little covers on each side of the steering wheel, a small on on the left and the one that covers the cruise control. then you take out the cover on the bottom of steering wheel. when you take that out disconnect the yellow plug for the airbag. then all you need is a 19mm socket and you almost done.

How do you remove an old steering wheel?

Look for threaded holes in the wheel hub assembly. These holes are designed to be used by the puller for removal. Attach the steering wheel puller using the appropriate bolts. As you slowly tighten the center bolt, it presses on the steering shaft, causing the puller body to lift, pulling the steering wheel with it.

How do you get a steering wheel lock plate off without tool?

Re: Steering wheel lock plate removal no tool

1. Turn the cylinder two clicks to the on or ignition position… whatever.
2. Use a flat bladed screwdriver and press in on the black retaining pin that is shown by the red arrow in the pic I modified.
3. Pull the lock cylinder out.
4. Voila!

What tool is used to remove a steering wheel?

steering wheel puller kit

What size gear puller do I need?

One rule of thumb in choosing a puller is the center bolt diameter must be at least ½ the diameter of the shaft from which the object is being removed. It is impossible to predict the exact force needed for every pulling situation. The amount of press fit and force of removal can vary greatly between jobs.

Who makes the best gear puller?

Our 10 Picks of Best Bearing Puller

1. 8MILEAKE Blind Inner Bearing Puller Hole Remover.
2. Orion Motor Tech 9-Way Slide Hammer Puller Set.
3. OTC Differential Side Bearing Puller Set.
4. PMD Products 16pc Blind Hole Pilot Bearing Puller.
5. Shankly 5 Ton Capacity Bearing Pullers.
6. OrionMotorTech 5-Ton-Capacity Bearing Puller.

Is a puller a hand tool?

Hand Tools – Clamps. Hand Tools – Cutting Tools for Bolts, Cables, and Strapping. Hand Tools – Gear Pullers.

How many types of pullers are there?

There are different types of pullers. For inside or outside use, separators and bearing puller. Three-armed pullers are mostly preferred to two-arm pullers because of providing more secure grip when pulling. Two-armed pullers are used in situations where space is limited.