How do you remove a power steering pump bracket?

power steering pump + bracket removal without removing pulley

Use the adjusting nut to move the pump all the way to the right as you are facing the pulley side.
Unscrew the nut holding the bracket to the lower crankcase horizontal surface.
Unscrew the nut holding the bolt to the back of the crankcase.

How do you change a power steering pump on a 1997 Ford Ranger?

To remove the power steering pump you need to remove the belt than pull the power steering pulley off to gain access to the bolts holding the pump on. Once the pulley is off remove lines and bolts and pump will come out. You will need a power steering pump pulley puller and installer to remove and reinstall the pulley.

How much does it cost to replace alternator pulley?

There is an average cost for a drive belt idler pulley replacement. Labor costs are between 64 and $81 while parts are between $79 and $83. Taxes and fees are not included in the estimate.

Can you replace just the alternator pulley?

In many cases it is possible to remove and install the overrunning alternator pulley while the alternator is still on the engine. The plastic protective cap cannot be re-used after it has been removed from the pulley. A replacement cap is supplied with the new part.

When should I replace my alternator pulley?

Rev up the engine to approximately 2000-2500 revolutions per minute (rpm). Then shut it off and listen for a buzzing sound coming from the alternator. If you hear a short buzzing sound (1 to 5 seconds), the pulley’s bearing may have worn out and the overrunning alternator pulley may require replacement.

How do I know if my alternator decoupler pulley is bad?

If you are facing chirping, growling or whining noises coming from under your car hood, facing battery issues, having trouble starting the car, headlights getting dim or too bright or the car smells of burning rubber or wire than it is time for you to get a check-up done of your alternator clutch pulley.