How do you remove a transmission cooler?
To use the wrench, slide the open end of the wrench over the cooler line, then slide the wrench down the line until it reaches the nut used to secure the line to the transmission. Use the wrench to loosen the nut located at the end of each line, then pull the line away from the transmission to remove it.
How do you change a transmission cooler line?
Step by Step Guide to Replace the Cooler Lines
- Raise the Vehicle. It would be best to work on level ground to ensure that your vehicle does not lean too much on the jack when lifted.
- Drain the Transmission Fluid.
- Remove the Old Line.
- Install the New Cooler Line.
- Replenish the Transmission Fluid.
- Double-check.
How do I know if my transmission cooler is bad?
Symptoms of a Bad or Failing Oil Cooler Hose (Automatic Transmission)
- Visible damage on the hose. From time to time, it is a good idea for you to inspect the components under your hood.
- Leaking oil around the lines.
- Transmission overheating.
- Deterioration in the rubber portion of the hose.
How much does it cost to replace a transmission cooler?
You will pay somewhere between $100 and $450 for a transmission cooler line replacement. The labor should be between $60 and $300, while parts can cost you anywhere from $40-$160.
How long does it take to replace transmission cooler lines?
Repairing the cooling line for your transmission can take quite a bit of time. You can expect to leave your vehicle at the repair shop for a day or two for this repair.
How much do new transmission lines cost?
A typical new 69 kV overhead single-circuit transmission line costs approximately $285,000 per mile as opposed to $1.5 million per mile for a new 69 kV underground line (without the terminals).
Which transmission cooler line is the return?
The return line begins at the top of the radiator on the passenger side, and runs back to the transmission. Again, I installed this on my 1995 Firebird Formula, with the 4L60E, the factory automatic 4 speed transmission.
Is transmission connected to radiator?
Car transmission lines connect your vehicle’s transmission to the vehicle’s radiator. Your car’s transmission lines are essential to preventing the transmission from overheating by carrying hot fluid away from the transmission until it is cooled and subsequently pumped back into the transmission.
How do I know if I have transmission cooler lines?
How to Identify Transmission Fluid Return Line for Installing Supplemental Cooler The surest way to find the return line in a transmission cooler system is simply to run the cold engine for about 15-seconds while it is in gear. Then immediately feel the two transmission lines.
Are Transmission coolers directional?
Can Transmission Fluid Flow Through Either Direction on a Transmission Cooler. The cooler can have fluid flow in either direction through it.
How do you size a transmission cooler?
Transmission coolers are rated by their gross vehicle weight or GVW, and this can go from as little as 10,000, all the way up to 40,000 or more! Based on the transmission cooler GVW chart shown below, the optimal transmission cooler should be at least 20,000 depending on the tow capacity.
Can I use copper tubing for transmission lines?
Copper will work fine. There is no problem with dissimilar metals at the fittings either…but if worried just use brass fittings. , copper is often used to replace corroded fuel and transmission lines. NOT on brake lines though as North American copper tube isn’t rated for the line pressure.
What can I use for transmission cooler lines?
Rubber transmission lines are readily available and are the cheapest option for transmission cooler lines. More often than not, your vehicle will have some rubber lines from the factory, but not nearly as much as it would metal.
Can you use brake lines for transmission?
Re: Brake Lines as Transmission Lines If that’s what he was refering to then, yes you can use it for transmission line. Most auto trans use 5/16 lines.