How do you remove an airbag control module?

Steps to remove airbag control module

First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor.
Disconnect the positive battery cable and wait 3 min.
You are now safe to unplug the airbag control module harness wiring plugs.

When should I replace my airbag module?

If there is an airbag deployment, it will need to be replaced with a new or used airbag. Airbags are not repaired and not repacked. The airbag control module however can be reset to clear crash history and then can be used again instead of purchasing a new airbag control module.

Can I install a used airbag module?

Getting a used airbag module is cheaper than getting a new one but the module will still need to be re-programmed. This is because when you install a different module inside your vehicle, used or unused, you will need to program it to your VIN, which requires a dealer to happen.

Do airbag modules need to be programmed?

When you buy a new control module, most of the time it will need to be additionally programmed /coded to the car to inlcude the VIN and the configuration. The most common reasons why the airbag light is on besides the obvious—if the car was in an accident—are clockspring and under-seat wiring (70% of the time).

Why does my airbag light stay on?

When this light is on, that means your airbags are deactivated. It means they will not deploy properly if you get into an accident. If your car’s battery has drained recently, it may have also depleted the backup battery that powers the airbags.

Can I drive with airbag light on?

It is not safe to drive with the airbag light ON. When the light is on, it means that there is a problem with the airbag system. When there is a problem with the system, it will not deploy the airbags at all in an accident. If your airbags are not functional in a crash, it may cause death or serious injuries.