How do you remove the cup holder on a Honda Odyssey?

How to Remove the Front Cup Holders on the Honda Odyssey

Pull the cup holder open.
Put the small slotted screwdriver in the tab on the bottom of the cup holder, and apply light pressure in an upward motion on the tab.
Remove the cup holder from the slot. Repeat steps 1 through 3 on the other cup holder.

How do you take the drawers out of a Honda Odyssey?

If you pull the drawer out there are 4 Phillips Head screws (two each side) on the inside of the drawer. Un-screw them and then you can lift/remove the drawer off of the sliding rails and get access to underneath.

How do you remove the ashtray from a Honda Odyssey?

There’s a tab in the middle-top that you can see when you open the ashtray. Push down on the tab and keep pulling the tray open, it will come out.

How do you remove the ashtray from a 2012 Honda Odyssey?

Using a small screwdriver, press on those plastic tabs to release first one side then the other side of the ash tray. Don’t press to hard or you can break the stops. Please don’t ask how I know that.

How do I remove the console from my Mazdaspeed 3?

Mazda 3 Service Manual: Console Removal/Installation

Disconnect the negative battery cable..
Remove the following parts:
Remove the bolts.
Remove the screws.
Pull the console in the direction of the arrow shown in the figure, then detaching clips A, C hooks B and guides D.
Disconnect the following connectors:

How do you remove the cup holder on a Acura TSX?

Pull up on the cup holder to remove it. It’s connected with some clips, so do it firmly but gently; you don’t want to break off the clips. If you pull it straight up, you will pop them off with no damage. Don’t pull the cup holder out all the way until you finish Step 3.

How do you remove the center console on a 2014 Mazda 6?

2014 – Mazda6 – Body and Accessories

Grasp the shaded area shown in the figure, and pull the console panel in the direction of the arrow (1) and remove it while detaching clips A.
Pull the console panel in the direction of the arrow (2) and remove it while detaching clips B.

How do I get my Mazda 6 out of park?

Mazda 6 Stuck in Park Causes

Turn the vehicle engine on.
Rock the vehicle with your foot off the brake.
Press the brake down when you have rocked toward the hill a bit. You want to “catch” it with the brake at the right time.
Apply light pressure to the shifter. You don’t want to break the shift linkage.

How do you remove the automatic shift knob on a Mazda 3?

Fully engage the e-brake. To remove the automatic shift knob you will need to gently depress the top of lock button with a thin flat screwdriver to pop off the cover.

How do you turn off climate control on a 2011 Mazda 3?

how to remove auto climate control:

Open glove box.
Remove dash trim piece over radio.
Remove radio (two screws and a couple of harnesses)
Remove shift knob (auto or manual)
Remove both the trim piece around the hand brake (requires opening the arm rest) and the trim around the shifter.

How do you remove the dashboard on a Mazda 3?

Mazda 3 Service Manual: Dashboard Upper Panel Removal/Installation

Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.
Remove the dashboard upper panel.
Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.

How do I remove dashboard?

Pry off the end caps on the sides of the dashboard with the trim stick. Remove the retaining fasteners under these end caps and at the center support. Detach any other electrical connectors that can interfere with the removal. Pull the dashboard out away from the engine compartment.

How do you change a dash light on a Mazda 3?

The brightness of the instrument panel and dashboard illuminations can be adjusted by rotating the knob.

The brightness decreases by rotating the knob to the left. A beep sound will be heard when the knob has been rotated to the maximum dim position.
The brightness increases by rotating the knob to the right.