How do you remove the drive shaft on a Chevy Silverado?

How do you remove the drive shaft on a Chevy Silverado?

How to Remove a Silverado’s Drive Shaft

1. Lift the Silverado’s rear end with the floor jack and support it on two jack stands, placed under the rear axle out near the spring perches.
2. Slide underneath with the socket set and tape.
3. Wrap electrical tape around the ends of the u-joint to keep the caps from falling off.

How long does it take to remove a drive shaft?

That’s very difficult to answer due to the multiple variables involved in removing and replacing hard to access components such as the center driveshaft on a front wheel drive vehicle like your Edge. However, in general, this type of job can often be completed in one business day; or less than 8 service hours.

How much does it cost to replace a driveshaft?

Usually, the Drive Shaft Repair costs will differ based on what caused the issue and how fast it can be repaired. If you just have to replace it, that would be anywhere from $500 to $1000. However, you can also expect the cost of the parts to be around half that number and the labor costs around $200.

How long can you drive with a bad driveshaft?

While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.

What does a bad drive shaft feel like?

A common symptom of a failing driveshaft is an intense shaking coming from underneath the vehicle. Worn out u-joints, couplers or carrier bearings can cause the driveshaft to vibrate. If you don’t get these components serviced, it can lead to further damage to other drivetrain components.

What happens when a drive shaft breaks?

A drive shaft break will result in loud clunking or grinding noises and a immediate loss of power to the wheels the drive shaft was driving.

What would cause a drive shaft to break?

What causes a driveshaft to break? Usually drive shaft issues can be attributed to aftermarket engine modifications (more torque) or tires (more traction, and thus a higher peak torque through the shaft). In both those cases slight twisting of the shaft near the failure point will be visible.

What can damage a drive shaft?

Vibrations from under the vehicle – Worn out u-joints or bushings can cause the driveshaft to vibrate. If you don’t get the u-joints or bushings serviced, it can lead to further damage to other drivetrain components. Please note that tire problems can also cause vibration problems, but it’s easy to tell them apart.

Is it hard to change a driveshaft?

That’s why your driveshafts are very important indeed. But, as they’re charged with the task of handling the power, they can fail over time. Changing your driveshafts is actually a simple task that a home mechanic can undertake without too much trepidation.

How much does a driveshaft cost?

Driveshaft prices can vary wildly, depending on what kind of vehicle you have, which shaft you need replaced, and whether it’s a single or two-piece driveshaft. Front driveshafts are commonly between $150 and $250; the larger rear shafts start around $250 and can reach $400 and above, possibly more for a two-piece.

Can a driveshaft be repaired?

Driveline Repairs Once the technician finds the area for concern, they will recommend a repair and service plan for your vehicle. Depending on the severity of the damage, recommendations may include service to a worn driveshaft, repair of a broken component, or an entire driveline replacement.

What causes a drive shaft to bend?

Why? Because when you vary the speed of a drive shaft, you not only vary the torque on all of its components, but you vary the torque on all of the components that are connected to the drive shaft Torque is LOAD. When you vary the load, at twice per revolution, you start to bend components.